I finished the installation this morning and it works well and looks almost professional. I used the female spade connectors for the new wires from the controller to the new switch center terminals (black and white about 9" long) after removing the wires to the motor, and male spades on new black and white wire about 14" long from the existing wires (female spade) to the motor. I stripped a section about 3" from end of the wires from the motor and connected to one end of the double throw switch, and then connected the other end to opposite side of the double throw switch. The 4 wires were run in a piece of heat shrink tubing (there is an opening in the motor switch housing for the wires to exit). I used the 4" project box where it looks like the original used a 3" box and might have been a little tight. The foam double stick tape worked great for mounting. All of the installation can be removed without any trace except for double stick tape marks.
Reply With Quote