I posted last night about my Craftsman saw motor crapping out. I took some of the advice and started trouble shooting tonight. First step was to make sure the switch was not clogged with sawdust. In taking it apart I noticed a lable that said "The power relay in this switch is gravity sensistive. Never turn on the power until the switch is mounted on the rails and the saw is upright." When I installed the T2 fence I had to relocate the switch and did not notice the label (in my defense, it was on the bottom) and did not put it in the correct position. So I put it in the correct position but saw tries to start but won't run. Did I burn up the relay? How do I check it? I'm going to check the Sears site and see if i can still get a replacement.