Hi everyone. I just bought the Hitachi C10FSH and the Bosch T4B stand. Has anyone used these two products together? It seems like I will need to mount the saw to a piece of ply and then to the T4B mounts is this correct?
Thanks,
deck
Hi everyone. I just bought the Hitachi C10FSH and the Bosch T4B stand. Has anyone used these two products together? It seems like I will need to mount the saw to a piece of ply and then to the T4B mounts is this correct?
Thanks,
deck
I put a 2x2 on either side of the saw and then ran screws into the 2x2 from under the T4B (Gravity Rise Stand)
Last edited by Rick Huelsbeck; 07-22-2009 at 10:47 AM. Reason: Added a picture
Rick,
You stand looks to have different mounts than mine, but I like your idea.
deck
I attached my C10FSH to a new model Rigid M-SUV.
Square sheet of BB Plywood attached to the miter saw, and then the plywood bolted to the MSUV.
Works great
BTW, I used the largest bolts possible and washer + lock washer.
I wouldn't trust using screws into the plywood to hold the saw... especially since i store it so the saw is vertical.
You may also consider lock nuts.