While setting up my new Grizzly G0690 table saw (I'll post more fully on that later) I noticed that the fence is twisted. Not twisted like a pretzel, but enough to notice. It creates a gap of roughly 25 thousandths of an inch gap, or about the thickness of my metal rule. The attached pictures show the front (square) and the back (flush at top, gap at bottom) -- it's easier to see if you click on the thumbnails.
This is my first real table saw, so I'm not really sure how concerned I should be about this. Is this a problem I need to contact Grizzly about, or is it just an acceptable imperfection that won't impact performance or safety?
Thanks in advance.
2009 Jul 11 014.jpg
2009 Jul 11 013.jpg
Reply With Quote