I have had a project on the books for a while needing to cut 1.5 x 4 inch FRP Tags from Sheet Stock. Finally got a good product using my Sears Hobby Grade CarveWright machine using a sled or carrier board. Cut a 6 inch long 1/16 inch end mill in half to fit my machine.
I would post this in the CNC section but the CarveWright is a hobby machine and the Big CNC's snicker at it....
I could have done the same thing on my Star 912 but I wanted to do a sheet at a time.
I used a PVC board for the sled and cut slightly through having placed double sided tape under the FRP. It held well. I will use the sled with a strip of double stick tape but have plans to drill 2 holes at each tag location and slot the bottom and make a vacuum sled.
This is a start. It cut like butter.... Installed the new ROCK Chuck to get rid of the old Ball Bearing QC or Quick Chuck that would wear and cause flutter of the bit.
AL