Can anyone recall the thread that involves making an adapter to hold a chuck for power carving which is able to adjust to different angles? He used a 1" x8TPI bolt.
[OP]
Member
Member
Keoni, I seem to remember one that used a ball hitch as the swivel portion on the holder. But it should not be to hard to get it figured out if someone can't find it.
Jeff
To turn or not to turn that is the question: ........Of course the answer is...........TURN ,TURN,TURN!!!!
Anyone "Fool" can know, The important thing is to Understand................Albert Einstein
To follow blindly, is to never become a leader............................................ .....Unknown
Member
look threw the posts over in the carvers forum. i beleive it was there, or at least a picture. it was a flower, maybe a rose, and i think it might have been tunred first. it was an actual flower not just a flat picture. i beleive the person who posted it was one of the people here who lives in the suburbs of chicago.
14x48 custom 2hp 9gear lathe
9 inch pre 1940 craftsman lathe
36 inch 1914 Sydney bandsaw (BEAST)
Wood in every shelf and nook and cranny,,, seriously too much wood!
Member
See this thread....
http://www.sawmillcreek.org/showthread.php?t=103093
Posting Permissions
Reply With Quote