Page 2 of 2 FirstFirst 12
Results 16 to 18 of 18

Thread: Jointer not Jointing so well...

  1. #16
    Join Date
    Nov 2007
    Location
    Edwardsville, IL.
    Posts
    1,617
    Just a thought. I did not see where you were from. Maybe a creeker with a straight edge close by could take a look.

  2. #17
    What's the reasoning for setting the outfeed table .001 below TDC of the knives? I don't understand that. Thanks.
    Stephen Edwards
    Hilham, TN 38568

    "Build for the joy of it!"

  3. #18
    Join Date
    Dec 2007
    Location
    Gilbert, AZ
    Posts
    239
    Quote Originally Posted by Stephen Edwards View Post
    What's the reasoning for setting the outfeed table .001 below TDC of the knives? I don't understand that. Thanks.
    Well, if your outfeed table is higher than the knives, then you wont be able to push it onto the outfeed table...you'll run into the front of it. By setting it just a little below, you ensure that you can get the board onto the outfeed table, and a thou won't be a noticeable amount of snipe on a board.

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •