Page 2 of 2 FirstFirst 12
Results 16 to 18 of 18

Thread: Jointer not Jointing so well...

  1. 03-12-2009, 11:01 PM #16
    Ron Bontz's Avatar
    Ron Bontz
    Ron Bontz is offline Contributor
    Join Date
    Nov 2007
    Location
    Edwardsville, IL.
    Posts
    1,673
    Just a thought. I did not see where you were from. Maybe a creeker with a straight edge close by could take a look.
    Reply With Quote Reply With Quote
  2. 03-13-2009, 1:34 AM #17
    Stephen Edwards
    Stephen Edwards is offline Member
    Send a message via Yahoo to Stephen Edwards
    Join Date
    Jan 2008
    Location
    Middle Tennessee
    Posts
    1,438
    What's the reasoning for setting the outfeed table .001 below TDC of the knives? I don't understand that. Thanks.
    Stephen Edwards
    Hilham, TN 38568

    "Build for the joy of it!"
    Reply With Quote Reply With Quote
  3. 03-13-2009, 5:37 AM #18
    Brian Kerley
    Brian Kerley is offline Member
    Join Date
    Dec 2007
    Location
    Gilbert, AZ
    Posts
    239
    Quote Originally Posted by Stephen Edwards View Post
    What's the reasoning for setting the outfeed table .001 below TDC of the knives? I don't understand that. Thanks.
    Well, if your outfeed table is higher than the knives, then you wont be able to push it onto the outfeed table...you'll run into the front of it. By setting it just a little below, you ensure that you can get the board onto the outfeed table, and a thou won't be a noticeable amount of snipe on a board.
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules