OK, what I really need is a better drill press, but meanwhile I need some new bits. I started out buying whatever was cheapest. Last night I threw out about 50 various bits and kept the 20+ that were sharp and did not wobble.
Please check me out and give me your experienced advice
I kept a small forstner set from Rockler. What has worked for you when I need more.
Do I need spade bits if I have forstners? What has worked well for you? I have seen some recommendations for Irwins here, even though they are cheaper than others.
I have seen top recommendations for Lee Valley brad point bits, so I'll plan on building a set from them.
I see recommendations for cobalt bits for steel. I only drill metals occasionally, but in the past I have used cheap, wobbly, dull bits that just make a mess and screech loudly. What brand of cobalt bits or other bits for occasional metal drilling?