Hi,
I was wondering if there are any tricks you all use to align certain pain in the butt things. I have a plaque order (5 plaques -2 different sizes). I'll be lasering them one at a time as they are pretty large. My issue is I normally put something like this against the rulers but the rectangular plaques are rounded on the face and the back edge, so the edge is higher than my ruler and I can't but it. I thought of just lasering the image on a cardboard and then positioning best I can using that but the design has a line border and if it's off it will be very noticable. I wish my laserbed had a grid on it, that would help. Is there anyway to do that to the laserbed? Any thoughts, tricks experiences?? Can you tell I'm a little nervous!! not only about that but I'll be using the laser foil for the first time (that I'll practice on something else first).