[OP]
Member
Anyone else get the free files from the 3d model club?
I ran the horse file in a scrap piece of walnut. The walnut was the wrong size for the file and I had to raster it against the grain, so it turned out less that stellar. I was impressed with the tool pathing and the detail looks good enough that tomorrow I will run it again in a piece of padauk.
will post pictures later.
Jim J.
[SIGPIC][/SIGPIC]Camaster Cobra 408 working table size 48 x 98
Wincnc,AspireII,PhotoVcarve,Cut3D
HX6090SE 60Wworking table 23”X36”
LaserCut 5.3
Coreldraw X3, photograV 3.0, Photozoom3
Sawmill Creek is financed in part through member contributions.
Many members just like you have found extraordinary value in becoming a financial supporter of SMC.
Contributor
Jim,
You're fast. Just got mine yesterday and was thinking about doing the horse in walnut, then use a black glaze over the finish. Their models are really nice, I've run a couple of them and have been very happy with them,
Bob
Friend of the Creek
got mine too!
jim
Posting Permissions
Reply With Quote