Search:

The 1.6” OD ended up being too small to adjust the rollers and get the chain drive cover back on. I went and bought a second 1.5” ID vinyl tube and got it slid over the 1.25” ID tube for a final OD...

I have two vintage dewalts and love the Freud LU83R010 combo blades on them. Crosscut and rip surprisingly well which is important for me as I switch between the two. As I understand d the negative...

I’m certainly going to give it a go with the vinyl. Will report back on how it works. From what I have read it has worked for others.

1.6” OD. Hope I can lose the roller down enough to contact the wood.

1-1/4” ID vinyl tubing is on the rollers now. I struggled with getting it to slide on maybe a 1/3 of the way so I took it off a put it in my oven on “keep warm” (don’t tell my wife!) and then it...

yeah, it’s kind of a shame to throw it all back together without getting the rollers properly recoated but I am intent on not investing the money until I make sure it can work properly. I’ll take...

Thanks for the continued good advice! Other than the upper rollers needing recovered, the only issue I will have is with one of the drum covers that bolts down to hold on the blade. It was missing...

I picked up the same machine on Monday for $50, not so lucky as to have refurbished rollers though. Your pictures were very helpful in figuring out how to get the head off and table unstuck. Now to...

I just picked up the same machine for $50 near Seattle. Had the same issue with stuck table and your disassembly pictures were very helpful. Hope I can get mine cleaned up and back together as well...