Search:

I'm waiting for the detail chisels to get back in stock. Also looking for a 3/4 and 1" and those keep getting moved out. :(

I had the same thing happen to me, was a tiny rock in a live edge I was working on and left 3 nice gouges in the bottom. All I did was take my find diamond stone and rub it on the bottom to take...

Fixed, after I adjusted the bar to be parallel with the base which I should have done before. (Only did the bracket las time.) then realign the bar to the stone everything came out as it should. ...

Progress has been made. I measure the bar for parallelness with the table and it dropped a bit over 1/32 over the length of the bar. This would explain the taper out of squareness that I'm getting....

I have the BGM and a Bench Grinder with a CBN wheel trying to follow your ultimate sharpening guide. I'm not sure if I really like the bgn bracket as its tricky to get it flat on the table with the...

I have been playing around this for a while and just seem to be making metal dust. I did my best to ensure the bracket is parallel my table as well as the bar parallel to the wheel face. It is a...

The lee valley wheel does not have a wide flat side. The side is machined though and I have been using it with my square against the guide bar to get it lined up horizontally and vertically. My...

Finally got it installed. I need to work at it a bit more to square it up both vertically and horizontally. First cut is very promising but a bit out of square still.

386081386082

Neat, I like how you undercut the support arm to support the wolverine cam lever. I was thinking of moving the cam lever to the back position and see how it works. I tested it with my other...

Next up? Getting it all setup and working with existing wolverine system. I have the wolverine adapter on special order at Lee Valley but I think I'll just put it to the side for now.

...

Its cheap but it works well. The motor is not balanced the best so it wobbles a bit starting up but when it picks up speed its fine. Its not the wheels either, it does it with out them installed. ...

Picked up the new 180 CBN wheel from Lee Valley to try out following Dereks Ultimate Sharpening guide. Need to wait till may to get the Tormek parts with the May $10 discounts.

383605

Which guide are you using?

Did you have to do any changes to Wolverine base to get it to not interfere with the BGM100?

383444

Work in progress. Need to get a cabinet made to store everything to help keep the work bench cleaner.

Aha! When I try in Chrome I don't get the header for the reply field. Firefox it works fine.

383443

Not much to look at but serves its purpose. I really need to replace the one on the...

I have watched his videos and tried it a few times but I didn't have anything that would fit in the kerf besides the saw it self. It worked well but I need to work on it more. I have some old hack...

* Lesson #4: When marking the pins, use a knife, but DO NOT score a deep groove. The saw falls into that groove and your pin comes out too narrow. (This experience is probably unique to me only. But...

This may be obvious but I can't seem to find it yet... How do I add attachments to my posts?

I currently have a wolverine setup but looking to add a BGM 100 to the system following recommendations of Derek Cohens website. I'm trying to avoid buying the Wolverine attachment for the BGM 100...

Thanks for the update, adds good closure to the thread as well.

Were you able to get the issue resolved? I picked up one today in Ottawa and found the same issue and will be returning it tomorrow and backorder one of the new ones coming.