Search:

Get yourself one of these pressure pots.

https://www.mddionline.com/sites/mddionline.com/files/images/9805p56b.jpg

What a nice surprise!

True it up after the bearings and shaft are put on the cylinder.

Put the drill in a drill press and turn it on, hold a sharpening stone to flat to the side of the drill, move the stone up and down a few times and check. any kind of stone will work, water stone,...

Hi Keegan,
thanks.

I have rebuilt quite a few Supersurfacers over the years, that was one that I rebuilt for sale, No it is not auto-return. It actually started life as a double machine. I...

Apparently not all of the dinosaurs died.

Hi Kevin,
I have a couple for sale. Supersurfacers are not thickness planers
contact me mark@solidwoodmachinery.com

Glue the panels and your good!

First; make sure that your stock is dressed flat, straight and square.

Flat; check on the jointer table, and check face to face.
Square faces; lay two lengths face to face on the jointer table,...

American Sycamore
473128

Rust-oleum, oil-based rust paint and primer. and Automotive body filler, sandblasting is best prep. I will show you more later, in the meantime you can check out my website on the rebuilds tab....

My first experience ordering online from walmart,
Just before Christmas I was doing a google search looking for a second monitor, and saw a great deal on Walmart A 32" 2K Viewsonic at an incredible...

Derek,

Flatsawn lumber will shrink and expand twice as much as quartersawn. This design is at best a problem done in solid wood, Quartersawn would have been less worrisome, but still, something...

Hi Derek,
The table will move across the 10' span, maybe well over an inch seasonally, It will shrink and expand due to changes in humidity. As Jamie said fasten it solid in the center and let...

I have dial and digital indicators, test indicators, 80lb 72" camelback scraped straight edges and a 6000lb 4' x 8' x14" surface plate , And I have never used any of them to setup or check my...

I don't understand what all of the dial indicators are needed for?

With a sense of humour,

as this may be a good learning experience.

A 10' wide slab of flatsawn oak may want to move from season to season you could be talking 1" or more across the 10'...

What tools you need depends a lot on what you plan on doing, but you can probably get some nice old tools online. I did some leatherwork back in the early 70's, I made boots and shoes, I asked...

Wow ! I would love to have a place like that.

You should be able to finish plane joints with a handplane to within a 0.001" fit
They don't have to be straight, they have to be a complimentary fit.
As has been said, a lot of jointer accuracy...

Using three;

Reference edge one and two fit.
Reference edges one and three fit;
Reference edges two and three show the error.

471938

Using two straightedges.

Top set: Reference edges fit perfectly together,
Second set down; Flip the lower one 180° , they fit perfectly.
Third set down; Both face forward but lower one offset to...

First thing to do is to understand how to verify flat & straight!

Two reference straightedges back to back wont verify straight!

You need three straightedges to verify.
Use reference surface...

I don't understand why you wont just do it with a router. Seems to me the be the easiest. you can do it in several passes and from both directions so that you get both ends clean without any...

Lower the infeed and outfeed tables co-planer, say 1/2" below the top dead center of the cutting circle.
Set your fence to 45 degrees.
Put marks or tape on the fence for reference start and stop...