Ronald...thanks for the link. I read your post and others about the helical head conversion and think I'll stick with the HSS knives for now. I guess if you joint pieces with a lot of varied grain...
Type: Posts; User: Brian Rohde; Keyword(s):
Ronald...thanks for the link. I read your post and others about the helical head conversion and think I'll stick with the HSS knives for now. I guess if you joint pieces with a lot of varied grain...
Fiinally had the courage to take it apart and access the three bolts on the table lip, loosening them slightly and tapping the table lip until it was level with the outfeed.
It took 3 1/2 hours...
I am nervous about taking the cutter head off. It looks that I loosen the belt, take the rabbeting ledge off, take the hex screws out of the bearing blocks and the cutterhead can be removed towards...
I recently bougth this jointer and it has had this problem since I acquired it. The infeed and outfeed are coplanar and the table lip is about .015 below the outfeed table at both the inboard and...
Sometimes the piece I am jointing will stop when it gets to where the table lip meets the outfeed table. I can see a slight difference in height where they meet. (they are exactly the same height...
Steve, thanks for the reply. I'd appreciate a picture.
I'm starting an end grain turning project and would like to use the Dennis Stewart arm brace and hooker tool or similar from Sorby or another source. Does anyone have a set they want to sell?
I'm...