You just suggested what is a violation of the National Electric Code.
Type: Posts; User: Tim Bridge; Keyword(s):
You just suggested what is a violation of the National Electric Code.
And the pylon would be a good spot for speakers or a holder for adult beverages.
Probably get banned for using that kind of language.:D
Thanks, I am going to try it.
What would you use to repair some chips on a melamine board edge?
I was thinking about using some West epoxy with some filler and white pigment.
Is the garage attached to the house?
It makes a difference code wise as to what you can do.
As a master electrician, I would install a panel in the garage and transfer whatever garage circuits...
Non shrink grout.
When you use a double pole breaker, both poles will trip at the same time if either circuit gets overload.
If you use single pole breakers with a handle tie, then only the overloaded circuit will...
You need the cover that doesn’t have the crushed corners.
https://www.hubbell.com/raco/en/Products/Electrical-Electronic/Boxes/4-in-Square-Boxes-Covers/809/p/1670695
397244
You will I’ll need...
You can check your Apple subscriptions by going into Settings, iTunes and App Store and then touch your Apple ID.
After you log in, scroll down to Subscriptions to see what you are subscribed to.
How would you go about cutting slots in walnut for inlay if 1mm wide brass strips.
Would you use a router or saw?
Ins there a 1mm router bit or saw blade?
Router plane?
Pretty soon the PC police will come after the trades and the male/female terminology.
NM-B cannot be run in any conduit underground or outside, it is a violation of the NEC 300.5(C) and 300.9.
These places are considered wet locations, and the inside of conduits are considered a wet...
Naugatuck was the home of Peter Paul Almond Joy and Mounds.
Now both are gone.
Its my home town too.
Naugahyde was invented by Uniroyal in Naugatuck CT.
If you want a clear epoxy, use the 207 hardener.
https://www.westsystem.com/207-special-clear-hardener/
3-1 ratio
I have the Laguna Resaw King blade on my 18” saw.
Cuts like budda :D
I think it would be more cost effective to use someone like https://brandingirons.com/ to make a custom iron.
I used them for a standard branding iron and the quality is very good.
See the 2014 NEC article 334.30(B)(1)
(B) Unsupported Cables. Nonmetallic-sheathed cable shall be permitted to be unsupported where the cable:
(1) Is fished between access points through...
Fleetwood Mac was much better before Buckinghan and Nicks joined.
Buchinghan is a good guitar player but Nicks voice is droning.
No saw stop here. I plan on making an aux fence for my miter guage
Does anyone use the Incra Miter Sled with their Miter Guage?
The HD it is. Thanks guys
With the five degree increments can you adjust the angle in between?
Is there any problem with the smaller teeth on the HD?