Search:

Thanks you guys for sharing your experience with me, it is very valuable information.

- The DW735 (DeWalt) small planer that I currently use has indeed rubber feed roller. This may explain why I...

I was reading instruction manual for a Grizzly planer. It says that you should not feed multiple board at the same time in the planer. It can result in kickback. This planer has no sectional feed...

Has the coupon been used? Did you get a coupon back after your purchase? I will be ordering a 20 inch planer and would be very happy to use a coupon. If they send me a coupon after my purchase, I...

Congratulation for your doors. Loose tenons are for sure a lot of work. And you don't want to mess with the router equipped with a 3-4 inch spiral bit in the maple. But your doors will last a...

Hi Van, thanks for making our education on the subject. I plan on buying a General 490 15 inch all cast iron band saw. Made in Canada, not imported.


Would you stick with a 1/2 inch max width...

Thanks for your answers!
I agree that 6 or 7/64 would not change nothing to my planing schedule, especially if a want to finish with a light pass on both side for finishing. I was just curious if it...

I'm in the market for a new planer. I looked at the Grizzly 20 inch with spiral cutterhead G0454Z and 5 HP motor. In their specifications sheet, they claim that the planer can take a 1/8 in. cut on a...

Shark Guard also. Make sure you order the 3 splitters, they are very valuables. I like to disconnect the hose on top of the blade to clean the top of the table saw when it becomes dirty.

I got a used PM2700 5 HP a year ago and I'm satisfied with it. Like some other pointed out, the set screw on the motor pulley went loose and caused vibration. Fixed with locktite. The mobile base is...

I have had great results with epoxy while gluing house doors. I too work alone, and I don't like being stressed. This epoxy has a pot life of one hour and reach 80% cure in one day.
...