Search:

Edensaw in Port Townsend or Seattle.

Not really a bad design, but after 20 years mother nature took her toll on the parts. Stainless steel would be a better choice but far more expensive. Use of grease as mentioned is a good idea. If...

A large majority of vehicles today have cycling clutch orifice tube operating system. There is a low and a high pressure switch. The low pressure switch is closed above 30 psi to allow...

Toyota has a TSB for this repair T-SB-0030-15 if your engine is a 2.4L. Its not a recall but a repair procedure for replacement of piston rings etc. Toyota allows up to 1 quart of oil usage per 1200...

Kudos on a fine piece. Thanks for the reply and pictures. But I'm not much of a visionist and need plans to build.

I am looking for plans to build and China Hutch for my wife. All suggestions accepted.

Thanks for the info.

If you're printing 8000 pages a year, get and Epson ink jet, no cartridges. We've use on in our business, 2 years and ink well still over half full.

Need to know if I should use grain filler or sanding sealer before applying finish.

I'm a small business owner and we do not accept american express any longer since when we did accept it it cost us almost $50,000 dollars in per transaction fess, interest and monthly fees. I you...

You can connect an amp meter in series with either battery cable or using and inductive amp clamp. Draw should be under 75 milliamps after all modules go to sleep, (may take up to 45 minutes on some...

Who is Mics

When replacing a battery on modern cars, you need to have power supplied to the power train control module and other devices so they can retain their memory. Also some cars will go into anti-theft...

This is normally not a DIY project. I've been in the auto repair business for over 40 years. The first thing is to install a pressure gauge to monitor fuel pressure when problem occurs. If there is...

I built mine out of 3/8 birch plywood torsion box style and covered with 3/4 in melamine. Attached to table saw with a full length piano hinge. Legs are 3/4 in angle iron with levelers on bottom and...

We stock a few bearings for automotive use i.e. alternators, starters and fan belt pulleys. Measured several bearings as followed. 6001-2rs id .470, od 1.10 in. 6200-2rs id 10mm, od 30mm. 6201rs id...

Bob Kaune in Port Angels WA will have almost any part you may need for your plane, antique-used. Very good in this area.

I have been using Waterlox for many years and used several ways to store it to keep it fresh. Adding marbles to fill can, co2 to push out air and none were 100 % effective. One day my wife was...

SOSS hinges would fill your needs, just google SOSS hinges. They come in all sizes and weight loads.

Any business in your area that repairs automotive alternators will have plenty of these on hand. We generally have 20 in stock as they have been used forever. Same bearings in my Jet jointer.

You may want to look at the Wood Rat or its sucessor the Router Boss. Having used the Wood Rat many times I can attest to the capability to make loose mortise and tennons, it performs very well. You...