Search:

Type: Posts; User: Bill Dufour; Keyword(s):

Page 1 of 20 1 2 3 4

Search: Search took 0.91 seconds; generated 18 minute(s) ago.

  1. Replies
    3
    Views
    149

    Just use the can opener on the bottom to make a...

    Just use the can opener on the bottom to make a short slit vent.
    Bill D
  2. Replies
    10
    Views
    287

    If you get snow swing out may not work. Other...

    If you get snow swing out may not work. Other then that swing out is the way to go. If your snow is measured in inches it should not be a problem.
    I know the OP is in Santa Rosa so he has no show...
  3. Replies
    10
    Views
    246

    PVC is not allowed per OHSA. I think pex or...

    PVC is not allowed per OHSA. I think pex or copper. Best to run copper for 10 feet or so before the filter/dryer. Hot steam will pass through a water filter. Slope lines down to drain ports.
  4. Replies
    39
    Views
    1,049

    Coleman fuel and its like is mainly naphtha. It...

    Coleman fuel and its like is mainly naphtha. It is a good paint thinner but not for shellac. I get mine at walmart house brand for about $8.00 per gallon which is cheaper then paint thiner.
    Bil...
  5. Replies
    10
    Views
    287

    On my shop door I installed full length geared...

    On my shop door I installed full length geared outswing hinges like the schools use here. Since it opens outward good luck kicking it in against nice solid door stops screwed to the framing. For...
  6. Replies
    47
    Views
    1,648

    For a gfci outlet I prefer to have the gfci...

    For a gfci outlet I prefer to have the gfci inside and daisy chain to a outside outlet. It is a little less convenient but the gfci stays nice and dry and does not fail from moisture. I have had two...
  7. Replies
    5
    Views
    308

    I have had to adjust the distance to lock out far...

    I have had to adjust the distance to lock out far away stuff. But I still occasionally search without the blinders on and it is interesting to see such distant ads.
    Bil lD
  8. Replies
    23
    Views
    805

    The way it works is that as soon as the virus...

    The way it works is that as soon as the virus gets into the wet body tissue the outer layer breaks down and the RNA strand is free to move into a likely looking cell and take over from the existing...
  9. Replies
    24
    Views
    882

    Three HD's within 5 miles of my home. The one in...

    Three HD's within 5 miles of my home. The one in the nicer part of town has limits on customers. The other two do not.
    Bil lD
  10. Replies
    47
    Views
    1,648

    Watch craiglist for used breaker panels, all the...

    Watch craiglist for used breaker panels, all the same make, I would have at least one sub panel on the opposite end of the shop from the main service panel. Also watch for heavy cable at least #8...
  11. recommnended blade tension is 15,000-20,000psi. ...

    recommnended blade tension is 15,000-20,000psi. A 3/4 by 0.032 blade needs about 800 pounds of force. I am not sure if this is 800 0r 1,600 pounds on the saw. I think they mean 800.
    For a...
  12. I think in a home shop just a normal cable clamp...

    I think in a home shop just a normal cable clamp will be fine. the fancy braided wire cable grippers are for industry where the cords are being pulled and moved all the time. I assume the cord will...
  13. Replies
    5
    Views
    308

    OT: Craigs list real estate question

    I have been looking for a retirement home for several years to get ideas on pricing and location in California. Only looking near the coast were the weather is better but prices are higher.
    I...
  14. Replies
    23
    Views
    805

    Alcohol above 85% will not bother the virus if it...

    Alcohol above 85% will not bother the virus if it is like other viruses. The high concentration alcohol will cause it to go into a defense mode and it can "live" in pure alcohol for several years. ...
  15. Replies
    20
    Views
    592

    many bandsaws become scrap when they are moved...

    many bandsaws become scrap when they are moved with the table attached. It falls into something or is grabbed and the trunnions break. Consider metal saws not just wood saws. If the FPM is correct...
  16. They are low speed so most any make is fine. ...

    They are low speed so most any make is fine. Depending on how hard it is to remove them I have no problem with ebay no name bearings. common size under $2.00 each. Name brand about $10. for for...
  17. Replies
    20
    Views
    592

    Older big saws tend to have poor blade guides. ...

    Older big saws tend to have poor blade guides. Often stackable metal plates which are missing so you can only run one blade width. Make sure there are modern blades guides to fit your saw before...
  18. Replies
    29
    Views
    923

    expanded metal mesh

    expanded metal mesh
  19. Too small at a four foot cube but, the fed ex...

    Too small at a four foot cube but, the fed ex flat rate box is a good deal for under 1,400 pounds. A tablesaw would fit but not the fence rails. 130-290 shipping cost. I believe that price...
  20. Never been the 30 miles to see the store but the...

    Never been the 30 miles to see the store but the adds look good.
    Located in Tracy Ca, near Stockton.

    http://www.professionalmachinery.com/default.asp

    Bill D
  21. surprised to see the hole at the worst possible...

    surprised to see the hole at the worst possible location and not a speaker box.
    Bil lD.
  22. Replies
    29
    Views
    923

    Shingles? Bill D

    Shingles?
    Bill D
  23. Replies
    29
    Views
    923

    Fiberglass, flame resistant cloth, wicker,...

    Fiberglass, flame resistant cloth, wicker, leather. metal screen. panel beater could make something for you. lath and plaster
    Bil lD.
  24. Mills and Drills Are you sure they are balls and not a dowel? ...

    Are you sure they are balls and not a dowel? They may be floating in the holes and held in by grease for assembly so they do not fall out. I would think about drilling them out and replacing with...
  25. Replies
    42
    Views
    1,950

    Easy way to stay safe is to bag the purchases...

    Easy way to stay safe is to bag the purchases into cold stuff that needs to come in and go into the fridge. Wash your hands and take a break. Everything else can sit in the car for 3 days then be...
Results 1 to 25 of 497
Page 1 of 20 1 2 3 4