I will. I think it will be a great product. It is reasonably priced. I have fooled around with box joints and various jigs and this looks like the best to me.
GN
Type: Posts; User: Galen Nagen; Keyword(s):
I will. I think it will be a great product. It is reasonably priced. I have fooled around with box joints and various jigs and this looks like the best to me.
GN
Thanks for that post. That is really interesting. Is the Keller the Journeyman? It appears that the Keller bits are quite expensive. Can you get them someplace for less?
Thanks
G Nagen
I have about 15.00 in a top and the flatness is about .004. 3/4 mdf with baltic birch supports. 1/64 flatness seems like a lot, especially if you are paying big bucks. I didn't put plastic...
Thanks for the info. Ultra looks like a good value.
Galen
In a you tube video I watched (3 segments) it was incredible how fast the follow cut half blind dovetails and then started in on a fancy corner post dovetail. It seemed like in a few minutes he had...
So bottom line, the Incra can make nice finger/box joints which are workable by having through the jig more than once. The micrometer adjustment seems pretty complicated to me.
Galen
Can you make them so they are not so tight? How are half blind dovetails to learn? Looks somewhat straight forward from the little I can see.
Thanks
Galen
I am tempted to buy an Incra Ultra Lite router fence. I want it to cut half blind dovetails and finger joints. I am wondering if any one has one and caries to comment on this product.
High...
36 inches. Wow.
Thanks
GN
How wide can one make a drawer with a Blum 562 and not have it unstable?
Thanks
Galen
They would hold better.
GN
If you go to this website http://www.drawerslides.com/p/562h5330c
and click on the locking devices pdf you will see the new locking device.
I am going to try to old locking devices. These...
This is what I have seen. I was not aware of this type of locking device.
Galen
I got a good buy on some Blum 562 undermounts with the soft close. I didn't buy the locking devices because I had some. Now it appears they have changed the locking devices. Does anyone know if...
Well, that will be how I will know. Interesting.
Thanks
GN
How will I know?
GN
Alan-can you say more about the new box joint jig?
GN
I did order one. For 29.00 I thought I would give it a try. I plan to bolt in to mdf. I probably will stiffen the mdf with baltic birch plywood. If it turns out I will post it. If not, you will...
In the end, plain old MDF would work well, if supported by some ribs/supports in a Pat Warner style.
Less expensive.
GN
I was going to put it over a chunk of mdf and use it like a 24 x 24 insert plate. I should have explained that.
GN
I noticed Woodcraft had some King cutting board sheets in their current flier. I am wondering how well this would work for a top of a router table top. No inserts, just cut a hole and install...
How big is the the router hole? Looks very nice.
GN
Many thanks. No panel cutters for me either. Too scary.
GN
I found where I can get Medite MDF. Just would like to know how big the hole in your router top is.
Thanks
GN
Pat-what diameter is the hole on your router table? Where can you get that Medite mdf? Specialty place?
Thanks. Really like the concept of your router table.
GN