Search:

Thank you all for your input. I finally had time to work on it again. I clamped the other side of the shaft in my aluminum lined vise and put tension on the gear with the gear puller once more. I was...

Yes everything with the woodtoof keys came off fine. It’s a good idea with the bearing splitter, I only used the 2 jaw bearing puller so far, but again I agree I’m afraid to break the sprocket.
I...

Ok, at the moment I can’t get it to seat fully either, it’s stuck in between fully seated and off.
I was thinking of pressing it on all the way and just spot weld it to the shaft, bad idea?
I have...

Unfortunately I don’t think I’m able to submit pictures with my thread yet.
The issue is not how to fix it but how to remove the gear from the shaft. It wiggles and moves about 1/8, but beyond that...

I picked up a late 80s general 130 planer recently. There was no infeed, I read somewhere that there’s a pin that likes to shear of if the machine is pushed to hard. I paid 200$ for the planer as I...

I agree with what the above about prep.
Then I always first spray the trim without masking anything towards the body of the walls. Usually when you spray against tape you get a hard line after,...

That’s how I would go about it.
If you have the edges of the existing tarpaper exposed for a few inches, you cut the patch a few inches bigger than the hole that needs to be patched.
You can then...