nice shop kelly, wish i could get mine looking that good:)
Type: Posts; User: Thomas Becknell; Keyword(s):
nice shop kelly, wish i could get mine looking that good:)
can't be of any help to you james but welcome to the creek:)
hi mark, welcome to the creek. i haven't been here too long myself but i have learned a lot from these good folks:D
great job richard. almost makes me wish i had an upstairs:D
welcome jason, can't help with ? but sure is a nice looking shop. wish i could get mine that clean & orginized:D
thanks vaughn, that info & pics helped a lot. temps down to 80's so a good time to start mine. will post pics while in progress.:)
i like the extention table. i want to build one for my ts3650 but i want to put a router under it.:) i bought mine becaus of the cast wings to. was wondering how to install the the table. thanks to...
hi vaughn, nice tool gloat. looks like a ts3650 under them. if so where did you get the zci for it. i need one . thanks
nice gloat Corey. let us see the results of all that sawdust you make with them. and it's nice to see jim is keeping an eye on everything.:D
thanks jim, that's the info i was looking for.;)
steve the boards wer 12'' wide. i run them through the planer & the glued them togather & cut them to the size i wanted.:)
i have built a dp table & put one coat of blo. i need to know if i need to put any more finish on it to make more durable. any help will be welcomed:confused:
hi bob,
a little late with this post. been away for a while. i got the rockler jig last week & love it. it will do three types of dt's half blind through & box [or] finger joints. easy to setup...
hi robert,
i don't know much about this but i think you have to set the bit to cut a little deeper than the material you are using.:rolleyes:
Thanks Jim:)
:confused: hi yall,
i would like to know how you put your pic at top & tagline at the bottem of messages. or if i am alowed to do so yet.
...
:) thanks to all for the warm welcome. i wondered why i was having so much trouble seting up my t/s & jointer. it's going to be hard to get out of using such close mesurments.
i am looking...
hi everyone,
i am new to the forum & woodworking. i have been lurking for awhile & decided to join. i feel sure that i can learn alot here. looks like everyone is eger to help with each others...