pm sent for Mark 2
Type: Posts; User: ed morini; Keyword(s):
pm sent for Mark 2
Those “glossy spots” are most likely resin that was not set by a temperature high enough to do the job. In my experience it does not stop for quite a while. Causing me to require my supplier to state...
Initially, I would ask when the stairs/house were constructed as that establishes the building code regulations for the stairs. With that base line you can determine compliance, not by the current...
I agree that white oak will be fine outdoors and for longer finish life rift sawn if available. For finishing there are two approaches:
1. Top coated with marine varnish (first coat gloss for...
Epifanes does make a matte finish that will accentuate the wood grain rather than the shine. I’ve used most of the Cetol products and they certainly have their well deserved place. I find them a more...
I think the biggest problem your going to encounter will be water intrusion at the bottom of the flat panels. I have for quite awhile felt that west facing door are subjected to the most severe...
About the only thought I would have concerning this plane is that it is a razee type. That being a lowered rear section. Numerous planes like this were used in the ship/boat building industry and the...
Those improvements will certainly help with the moisture issue. I would add a plastic layer over the dirt that is going to be concreted. The concrete will take longer to set up but the plastic will...
One of the biggest mistakes is to put a conventional floor sander on one of these floors. Its asking for trouble. The cupping in the floors is, I believe, due to the natural condition of the wood...
I"ve had 2 sets on these chisels for 40 years and they have held up very well. If I recall correctly they came with a rather steep angle from the factory. Worked terrible in hardwoods and tolerable...