Search:

Glenn,
Thanks for the info. My son and I have limited experience with jointers. So I will proceed cautiously, been watching a few videos.

Hello Mike
The jointer will adjust but after some use the 90 degree setting on the fence goes out of adjustment also the beds dont stay coplanar.Its at my sons house I haven't looked at it myself...

Hello,
I have a used Grizzly 8" model G0490W jointer with standard blades.
Has anyone with this jointer had issues with the jointer not holding the coplanar adjustment.

Thanks
Scott

Thanks everyone for the advise
I think Ill start out against the wall and see how it works out
Since my shop is narrow

Hello William
I'm thinking of raising my lathe, and putting a VFD on it. I come across 3 phase motors at work and work on a lot of equip with VFDs
What are you making your riser block out of?...

Hello,
I have a fully restored Powermatic PM90 lathe , that I hope to start using.
I/m a beginner and have only turned a few times.
I'm laying out my shop and I'm not sure how much space to leave...

In my case I would be buying it to primarily break down plywood, but occasionally may want to straight line some lumber .
With a wedge in the kerf I don't see the riving knife as a deal breaker. ...

I'm also ready to purchase a track saw debating between the Festool and Makita.
If two short Festool tracks at 110" are barely long enough to cut a 8ft board
Then how do you crosscut a 4ft board...

I'm just getting into woodworking, but I remember cutting out 250 blanks for the guns when the kids were in cub scouts. I think they were just L shaped with a cloths pin on top.

Haven't used the...