Search:

FYI, update for anyone reading this, after having so much difficulty trying to get my blade runout set properly using the miter slot to the left I checked the miter slot to right of the blade. The...

Thanks Glenn, I followed your advice about tightening the table bolts. I watched the dial indicator and saw no movement. I tried the same procedure with several saw blades, one new one just out of...

Measuring runout on the blade not wood.

Owners manual says .002. I have not talked to sawstop yet. Called and left a message but have not heard back.

I have an Industrial Sawstop. I noticed that a broad I cut to a specific square size did not measure square cover to corner. I checked the saw for blade alignment and found it to be out .009. I...

I have a 5hp Oneida cyclone with a 6" line running about 20' from planer to collector. There is a trash can collector between planer and main 6" line. I have run the system without the trash can...

I have a Powermatic 209 HH planer. I have had problems with the dust collection since I first installed it. Dust seems to be picked up on the right hand side of the table fine but not on the left. ...

Steve, I have seen a system (home built) that incorporated 2 short pieces of 4" PVC placed in-line to act as a vacuum reservoir in cases of lost power. Are you familiar with such an item and what do...

Don, how did you seal around the bearing and the hose barb? I just left a question on the turners forum about making my own chuck adapter. I can't get it to seal with affecting the rotation? I...

I tried building my own adapter from information obtained on another website. The writer even gave the part#/ drawer# at Lowes for the sealed bearings that he used successfully( I guess). I got all...