Search:

Type: Posts; User: Kayla Anatoli; Keyword(s):

Search: Search took 0.00 seconds.

  1. Don’t know if you’ve made a decision yet but I...

    Don’t know if you’ve made a decision yet but I can’t say enough good things about Jim Earman and Jimani Lasers. They go above and beyond in helping their customers whether it’s the hardware or the...
  2. The inexpensive Amazon USB to Centronics cable...

    The inexpensive Amazon USB to Centronics cable worked just fine. $9 if I recall. Thanks!
  3. Replies
    8
    Views
    3,986

    There are no mirrors to contend with in a fiber...

    There are no mirrors to contend with in a fiber laser system. Safety glasses rated for 1064nm +6 or better, if it’s class IV open frame then you need a booth or some manner of protection, treat it...
  4. GCC LaserPro Mercury 1 & USB to Parallel cable?

    The Mercury 1 is parallel port or serial port input. I’m running an old Dell 4550 at the moment without any issues but I’d like to gain a little space and upgrade the computer. Does anyone know or...
  5. Great, thank you so much for taking the time to...

    Great, thank you so much for taking the time to do this! I also ran at .8% and had the same result, not quite thru but enough that I was able to snap it free. Glad to know that after some maintenance...
  6. Using 1/8” Romark, with the protective film...

    Using 1/8” Romark, with the protective film removed, the speed setting to achieve a clean cut at 100% power (25W spec Synrad laser) is 0.6% Timing it works out to be between 8-9 sec/in. Laser has a...
  7. GCC LaserPro Mercury 25W Power Evaluation

    I acquired an original Mercury I /Pinnacle 25W laser essentially for free. It’s in nice shape, the Synrad tube has a mfg date of 2005. I was told the laser was weak and probably needed a re-gas. It...
  8. Replies
    32
    Views
    47,350

    Check out Jimani Laser in CA. Jim recently...

    Check out Jimani Laser in CA. Jim recently started importing a Chinese laser. He had them toss the Chinese controller and the EzCad software. They were replaced with a ScanLab controller and a...
Results 1 to 8 of 9