Search:

Type: Posts; User: Adam Beaudoin; Keyword(s):

Search: Search took 0.00 seconds.

  1. Replies
    15
    Views
    1,358

    That's what I figured, too. I'll wait for...

    That's what I figured, too.

    I'll wait for another machine another day to have resaw capability.
  2. Replies
    15
    Views
    1,358

    Thanks, I'll keep an eye out for Grizzlies.

    Thanks, I'll keep an eye out for Grizzlies.
  3. Replies
    15
    Views
    1,358

    Thanks, Mike. Does the recommendation for Delta...

    Thanks, Mike. Does the recommendation for Delta still stand for the smaller models? Found a 9" delta for $70 that at least from photos looks pretty well taken-care-of.
  4. Replies
    15
    Views
    1,358

    I mean, is there a compelling reason to not buy...

    I mean, is there a compelling reason to not buy this tool used? For $300 or less there are lots of used 14"+ models, and used 9/10" ones seem to cap out around $100...
  5. Replies
    15
    Views
    1,358

    Used bandsaws

    I'm currently an all hand-tool guy, but looking to add a used bandsaw to my setup. There's a ton out there, but are there any brands/models that I should keep an eye out for, or especially avoid?
    ...
  6. Lumber yard suggestions - Pennsylvania

    I'll be driving from NY to OH in about a week, and the quickest route takes me through PA (84 to 81 to 80).

    Any suggestions for don't-miss lumberyards along the way? Particularly any with a good...
  7. Replies
    1
    Views
    1,177

    Back bent gouges

    Can someone clarify the use of a back bent gouge? If it's used for paring a convex surface, why is it it still outside-bevel? Once you turn it upside down so that the profile fits the scallop, the...
  8. Replies
    2
    Views
    1,537

    Question about tang slot

    I bought a 15/64" (just what was available for a good price on eBay) carbide rod to make a burnisher. If I make the tang hole with a 15/64" bit, will the fit be too tight for the epoxy to hold? My...
  9. Replies
    6
    Views
    514

    Will do. By the way, does anyone have an email...

    Will do. By the way, does anyone have an email address for Willard Brothers? The one listed on their website bounced back.
  10. Replies
    6
    Views
    514

    Thanks, Phillip, I'll check out Willard Brothers....

    Thanks, Phillip, I'll check out Willard Brothers. I'm planning to carve it, actually. I've carved some AYC before, and while a bit hard it is nice. I've heard of Sugi's use in traditional Japanese...
  11. Replies
    6
    Views
    514

    Sugi cedar

    Anyone know where I can get a little bit of Japanese cedar (Sugi, Cryptomeria) either online or in the Northeast US? There's a bit on eBay, but it's all either green or heavily figured, and I'll be...
  12. Replies
    2
    Views
    1,998

    Yellow Cedar

    Anyone know an online source for carve-worthy Alaskan Yellow Cedar? Or Port Orford Cedar, I suppose.
Results 1 to 12 of 14