[QUOTE=Lee Schierer;3313633]If the grain directions align you don't have to worry too much about dimension changes. Cross grain joints will be a problem, so you have to make provisions for...
Type: Posts; User: Brian Runau; Keyword(s):
[QUOTE=Lee Schierer;3313633]If the grain directions align you don't have to worry too much about dimension changes. Cross grain joints will be a problem, so you have to make provisions for...
Planning on building a 4 x 4 table out of cypress. I should have enough lumber in my inventory to do a top that is 1-1/2 or 1-3/4 thick. Planning on the apron for the top to be @ 5" wide with 90...
Lee, thanks for the feedback. Brian
Absolutely not, but quality? Brian
what do you think of this? Teak like? thanks brian
https://www.samsclub.com/p/6-pc-dining-set-teak/prod9900191?xid=plp_product_35
Thanks for the suggestion. Brian
I can't get ipe locally either. Had same problem with mold/mildew even using a marine oil based stain. May do cypress again and use the "one time" finish on it. Thanks Brian
Starting to thinking about making a pole lamp out of quarter sawn oak and thinking about two different ways to do it so I get quarter sawn faces on all four sides.
1. Use lock miter bit and...
I built one out of cypress years back and time to replace it. Teak is going for $75 bd ft locally, so that's a no go. What other wood would you consider for an outdoor table? Would mahogany hold...
At my age these become more frequent, "senior moments." Brian
Don't know if I dropped it, could have. It is square, but not true flat, tapers zway from square towards the end with the handle. Test this morning, as long as I don't put downward pressure on the...
It is consistent across the face. Thanks brian
Ok. Removed the stop and sat the tool on the edge of my cast iron sawstop table saw. With pressure down on the knob it wanted to rock a little bit even with it pushed into the edge of the table. ...
Bill, I apologize if I come off as an "oil seal" snob. I sold Chicago rawhide as a factory rep for 7 years. Wouldn't recommend a speedi sleeve under a radial bearing. Might work, but not designed...
Sad. Brian
What runs against the shaft at this spot that has worn the shaft? Thanks. Brian
Registration is $100 per your statement, I have always thought document fee was just a profit add on? I always negotiate a price that is "all in." No extras or surprises.
Cool picture. My wife and sat in the back yard here in Indianapolis and watched. Perfect day for it here, 75 and clear skies. Brian
My wife keeps our credit frozen so we can't get ripped off. Unfreeze it when/if we need to use it. Brian
Good information, thanks brian
Thanks Jim.
Thanks to everyone. Been using my Domino for a few years now, recurring problem. My workpiece is always clamped down and overhangs the work surface. I do plunge with my hand on the front hold...
Happens to be 3/4" stock, but I don't think it matters how thick the stock is since I am referencing off the bottom of the fence and the same reference face/plane on the work. This is a piece of...
Building a coffee table and assembling the pieces for the skirt pictured here. I always use painters tape so I can see my marks for my line up and I make oversize mortises in one side of the...
what do you think of . Brian