Does anyone have a copy of the Dec. 1984 issue of Wood magazine. I am looking for the plans for a toy car carrier in that issue. I built one years ago for my son, now I’d like to build one for my...
Type: Posts; User: Harry Niemann; Keyword(s):
Does anyone have a copy of the Dec. 1984 issue of Wood magazine. I am looking for the plans for a toy car carrier in that issue. I built one years ago for my son, now I’d like to build one for my...
Be sure you use the correct blade type to avoid kick back. So many people think these saws are dangerous but they are not if you have the right blade. The blade must have a zero or negative hook. if...
Count me in Harry Niemann
I was disappointed with Forrest. I sent in a WWII and it came back with run out which was not there before. They said they don't check for that.
There is a false Dewalt website (dewcxeo.com)advertising greatly reduced prices for Dewalt tools. 735 planer $99.00, 6piece tool set $99.00. It is a scam. They charge your credit card or pay pal...
There is a false Dewalt website (dewcxeo.com)advertising greatly reduced prices for Dewalt tools. 735 planer $99.00, 6piece tool set $99.00. It is a scam. They charge your credit card or pay pal and...
Had my WWII sharpened by Forrest recently, came back with runout. They said they don't check for this, wanted me to send it back for extra cost repair.
The reason people consider RAS saws dangerous is because they use the wrong type of blade. Using a table saw type blade with a positive hook angle can cause the saw to jump forward. You must use a...
What's the best chute spray to prevent clogging?
Not sure about delta, but when my craftsman brake failed, It was an open diode in the motor. There is a dual back to back diode assembly in the motor that causes a back EMF effect to brake the motor...
I used an old fashioned window weight as a counter weight.
This happened to me on my 22-560 about 10 years ago. The drive pulley on the cutter head sheared off. I contacted Delta and they sent me a slightly redesigned blade cylinder head. Have not had a...
Floor laminate works very well for inserts.
Don't know why you would need something this hard for an insert. I have used laminate flooring very successfully for this.
The older you get, the less you care about what time it is. So the answer is no.
I have had this press for over 25 years and it has served me well. You can drill to the center of a 32" circle and angle it to drill holes at an angle. A great investment.
The other possibility is that the chain is stretched and needs replacement.
So many people are afraid of these saws. There can be a kickback or forward if you do not have the correct blade. Be sure you use a negative or zero hook toothed blade. Table saws use a positive hook...
Contact Generac.
I have used Laminate flooring with success.
Using a needle you can remove the seal and clean and repack them. I have had good success with Vaseline.
Does any one know of a lower cost 10" blade with 0 or negative hook. Seems like every one I see is $50.00
on up.
My Dewalt ROS had a rubber shield covering the switch. This shield often interfered with the switch action preventing it from going completely off, and sometimes made it hard to turn on. I cut out...
The project is a 4' square coffee table with 150 + !/4" red oak parquet pieces glued to 1/2" plywood with polyurethane construction adhesive. There will be a 4" apron around the edge. The finish...
Red oak parquet 1/4" on 1/2"" plywood poly finish