Search:

Type: Posts; User: Bill Dufour; Keyword(s):

Page 1 of 20 1 2 3 4

Search: Search took 0.31 seconds.

  1. Replies
    16
    Views
    189

    I wonder if these home remedies for night time...

    I wonder if these home remedies for night time cramps are really just get up and walk to the kitchen then walk back to bed. Oh, while in the kitchen eat or drink a small amount of something odd to...
  2. Replies
    16
    Views
    189

    My wife drinks it in the middle of the night if...

    My wife drinks it in the middle of the night if needed. There have been legitimate research studies that show it works for athletes. Not sure if that really correlates with night time cramps. ...
  3. Replies
    2
    Views
    126

    I would think are just regular M3 class with...

    I would think are just regular M3 class with rubber seals.
    Bill D
  4. Nail gun will shoot through a metal truss connector plate

    I am in the process of adding rafter ties in my garage. I just got a small compressor and switched from hand to my placement nailer. Unfortunatly They have to be attached over the rectangular...
  5. Replies
    167
    Views
    28,102

    True story, no joke. Political correctness has...

    True story, no joke. Political correctness has gone too far.
    I was reading about if there are any legitimate medical reasons not to get vacinated. This was from Yale or Harvard medical they said...
  6. People are right this is to insulate the roof of...

    People are right this is to insulate the roof of the garage before the saw is in the way. I would like nice clean cuts since it will be seen from below. Just was not sure if polyiso was as easy to...
  7. Replies
    48
    Views
    1,730

    What happened to the little Indian made...

    What happened to the little Indian made van/pickup that was going to run on compressed air? I think it was Ta Ta motors who bought Land Rover or some such.
    Bill D
    ...
  8. Fernco makes them in all sorts of sizes. 5 and 6...

    Fernco makes them in all sorts of sizes. 5 and 6 " for pvc, steel, cast iron. clay orenegburg, asbestos etc.
    For mine I took a 18" long piece of 6" PVC. I cut out a wedge lengthwise that tapered...
  9. Is the motor turning while the drum is sitting...

    Is the motor turning while the drum is sitting still. If so sounds like a bad belt or bad bearings. Do home owner dryers even have a rear bearing or is all rub pads.
    Bill D
  10. Cutting polysio foam insualtion with a track saw

    Wondering if anyone has tried using a tracksaw to cut polyisocyanurate insulation. Did the chips clog up the dust port. Did the track slip on the foil facing? Seems like such a plan may be easier...
  11. Replies
    19
    Views
    675

    Endcaps have to be flush with the outer diameter....

    Endcaps have to be flush with the outer diameter. maybe turn some plugs on the lathe.
    Bill D
  12. I would assume Linden or lime. Is this a trick...

    I would assume Linden or lime. Is this a trick question? Birch is common in Scandinavia.
    Bill D.
  13. Location might help with species choice,. It was...

    Location might help with species choice,. It was probably local trees not imported from across the ocean unless you are on a island or a continent with few trees.
    Aland islands?
    Bill D.
  14. Replies
    7
    Views
    499

    No idea but our friend just returned some to the...

    No idea but our friend just returned some to the store. She saw something on tv that her brand has ingredients that can cause cancer.
    Bill D
  15. Replies
    19
    Views
    675

    conduit costs more then white pvc pipe in equal...

    conduit costs more then white pvc pipe in equal wall thickness. All pipe and conduit comes in thin and thick wall. Round steel rebar stakes will not crush under many loads but the diameter is...
  16. Replies
    8
    Views
    550

    Any idea what was in the golf bags.

    Any idea what was in the golf bags.
  17. Replies
    6
    Views
    350

    Maybe flip the breaker off for a few minutes? ...

    Maybe flip the breaker off for a few minutes? Can you access any buttons with the door closed? Not on our Bosch. It is so quiet it has a little light to tell you it is running. I belive it is the...
  18. Replies
    20
    Views
    1,655

    Coleman fuel or the walmart vesion is about $8.00...

    Coleman fuel or the walmart vesion is about $8.00 a gallon last time I bought some. It is basically naptha. Works fine to thin and cleanup Tractor Supply oil base paint.
    Used to use kerosene for a...
  19. Replies
    48
    Views
    1,730

    Anyone remember the Subrau Brat pickup truck? ...

    Anyone remember the Subrau Brat pickup truck? For some reason it had a rear facing seat in the pickup bed out in the rain. I think there were limits on trucks imported from Japan.
  20. I prefer gravel or aggregate over concrete. Less...

    I prefer gravel or aggregate over concrete. Less problems if it leaks. MY DP base ballast is old motors and nuts/bolts/nails. No chance of wayward dust getting into sliding surfaces and causing...
  21. Replies
    13
    Views
    796

    Sounds like you were multitasking. Was it a...

    Sounds like you were multitasking. Was it a shopsmith combo machine or one of those tablesaw,jointer, drill press, and one motor set ups from the 1950's?
    Bill D
  22. My vertical air compressor would rock a bit when...

    My vertical air compressor would rock a bit when ever it turned on or off. I coulds ee it move from across the room. So I stopped by the side of the road and picked up some big rig recap treads,...
  23. There should not be any calcium deposits since it...

    There should not be any calcium deposits since it is distilled water. Seems like bleach would be more effective to remove critters. But your method works.
    For some reason they installed an...
  24. Replies
    48
    Views
    1,730

    My 2000 Ford ranger much of it was made in Mexico...

    My 2000 Ford ranger much of it was made in Mexico The seats, the dash wiring. The steel wheels came from Brazil. The automatic transmission has been from a French company built in France since the...
  25. Replies
    16
    Views
    725

    That many biscuits all at once will push you on...

    That many biscuits all at once will push you on being fast enough to get it all done before the biscuits swell and you can not pull it all together. Hence the screws to hold things while the glue...
Results 1 to 25 of 500
Page 1 of 20 1 2 3 4