Search:

I dunno if this is correct spot for this but I’ll give it a go.
Is an air drier beneficial when spraying water base finishes? I’m not opposed to spending a few dollars to buy a decent refrigerated...

I'd buy that but I don't think shipping to South Dakota would work out very well. In cost and hassle.

$300 pallet jack and I can move my 8 1/2 slider just as easy as anything on built in casters.

One thing I don't think folks realize is that the outfeed table on a slider "slides" out of the way when you need the space, unlike the a fixed outfield table on a normal cabinet saw. You must still...

My woodmaster drum sander just uses a dc motor for the feed and a simple reversing switch. No three phase on it.

I think it's so all ther motors that might get plugged onto the same outlet run the same direction. '

I have a few 3 phase machines. A rotary phase converter and a VFD. I like the 3 phase options and it works well for me. But, I think resale on single phase machines is probably higher if you ever...

thanks I just ordered a set of three.

I paid $4.5 per square foot. They ground the floor first then put down one or two (I can't remember) coats of color, then 100% chip coverage and finally a top sealer coat. When they put the chips...

I have a polyaspartec floor in my new shop. It’s great. I don’t know if it’s really any different than an epoxy floor but I think it’s less of a health risk for the installers. It’s pretty impervious...

Mike, where did you find the CBN disks? I looked a bit but only found them in one place at $59

We’ll that is significantly cheaper. Maybe I’ll take a run at Siko and see if they can give me a better price. If not I’ll likely go with the Proscale too.

Im just thinking about the fences and their flip stops for now. I have bolted my Incra positioner to the outrigger table in the past. It’s ok but I would still like something a bit better in the...

So how did this all work out you might ask.

Just excellent. I built a plenum withe cheapo furnace filters to catch most of the overspray before it gets to the fan. There is plenty of airflow but...

That spider is pretty cool. And time consuming I’m sure.

Great! Electronics, that's above my pay grade.

Lambtoolworks got back to me. They don't offer a system for the MM slider. I called Siko, they are very helpful and have done this application quite a bit. I'm getting some prices and technical...

Yeah I saw Sam’s mods. I was hoping to just buy a solution but it’s definitely an option. And likely a bunch cheaper.

I saw that. But it says the parallel fence fits both Felder and MM. So maybe there is a chance it can work on a MM.

Does anyone know if the Lambtoolworks digital flip stops work on a MiniMax saw? I have a request into the Lambtoolworks site but I thought someone here might know or know of a retrofit.

I know your actual tool layout isn't reflected in your model yet but one thing I think could have improved my new shop addition is:
I have my garage access door like you off center on the gable end....

I don’t have a return baffle but I do have a filter plenum. I lined that with old shag carpet as recommended to reduce noise. I don’t think it made a ton of difference. But my cyclone is in an...

Not to speak of closets but I find it pretty funny that most of the pics of peoples dust collectors and piping show that the outside of the dust collector systems are covered in dust.

I just use the suck your tape measure up method.
And my particle counter.

Thanks for posting this. I really like the design. I put it on my next up project list.