Search:

Thanks john

Finishing a bench with varnish. Accidentally scratched the finish. Would like to repair it instead of sanding and recoating. Any ideas are welcome!

FOR Sale I have the woodpeck rip flip 52” rip capacity that goes on the saw rail. (Saw Stop version) New in box. It cost $219.99 Will take $190.00 buyer pays shipping Or pick up in...

I wrote a long answer to your advice and I didn’t do some thing right to get it posted. Thanks. I’m going to set back and think the whole thing out. The place I want to glue up is on the rim of...

Thanks for your comments

David. Thanks, I considered that and that may b a better choice. Thanks

I had a “wet “white oak bowl come out of the chuck. Broke a chunk out and cracked it when it hit the floor. I am wondering if epoxy (T-88))would work to repair the crack. The mortise was cut...

I am pretty sure the woodworkerssupply sell the same exact bits. You may want to compare prices.

I think that is smart. Woodworkers supply also has premium chisels. Also get the cone shaped diamond hone to maintain the chisels. There is also a lubricant to help the bit from overheating. ...

That is an option to consider. Thanks.

Said I would check today, we have a solid sheet of ice, unable to go out to check. As cheap as they are on Amazon I suggest you buy what you want, with free shipping. By the time you pay...

There are difference dia of the barrel. Not sure what a PN 701 uses. I have extras but will have to measure the dia for you to see if they will work. Tomorrow I can check

I think I will see what my son wants, but fitting the two pieces together as suggest isn*t the way to proceed.

they are live bark edge so turning the other way really isn’t an option either. ...

I think you are correct!

I have two slabs cut from the same bigger slab. Friend brought them to me, to get them in his car he cut it in half. Has anyone ever rejoined them back together and it didn’t looked botched. ...

You might also check, the saw stop is bad about saw dust gathering in the rear of the rear posts. Look in the Manuel, it addresses that issue. I found that a vacuum is better to remove it than...

My friend in West Virginia has a McNaghten system for sale at 1/2 price he will post here as soon as he gets approved. Good way to start.

Thanks, will look at it

thank you. Will look at the link

The ones I’ve done in the past I squared up the corners (sharpened)

thank you for the suggestions. That helps

I have a 3” slab that has a crack top and bottom, not separated very much but would like to support it from getting worse. What is a good rule to determine the width and length of the butterfly...

ok, thanks.

Thanks, good to consider!

Sounds like we are barking up the wrong board