Search:

Type: Posts; User: John Stankus; Keyword(s):

Page 1 of 13 1 2 3 4

Search: Search took 0.01 seconds.

  1. Replies
    17
    Views
    867

    Most likely NOT! At least not taking in stuff...

    Most likely NOT! At least not taking in stuff from outside the school

    Chemistry departments have to pay for hazardous chemical disposal. It gets more expensive if you don’t know what’s in there...
  2. Replies
    21
    Views
    1,274

    There also possibilities of where the...

    There also possibilities of where the interference is getting into the receiver. If it’s traveling through the power lines or lines to sensors a ferrite choke might help ....
  3. Replies
    21
    Views
    1,274

    A resource on rfi ...

    A resource on rfi

    http://www.arrl.org/radio-frequency-interference-rfi

    It can be a bit more complicated than just looking for 315 MHz
    It can be that the sum or difference of two signals comes...
  4. At this point, I'm not suggesting classes that...

    At this point, I'm not suggesting classes that you would need to pay for with your GI Bill. Check out some of the intro classes at places like Woodcraft.

    Here are some of the classes listed at...
  5. I am going to be a bit more contrarian than most....

    I am going to be a bit more contrarian than most.
    1. Go take some classes so you can figure out how you enjoy working
    2. Join a local woodworking club if there is one around. You gain by seeing...
  6. Replies
    46
    Views
    2,358

    I bought a pump and gauges as well. Toughest...

    I bought a pump and gauges as well. Toughest part of the install is making sure the flare joints don't leak. You can get preflared tubing in various lengths. acwholesalers out of Florida is...
  7. Laminate surface finish (texture) for outfeed table

    I'm thinking about finally building a small outfeed table for my tablesaw. I noticed that on the borg websites the laminate sheets can have different surface finishes (matte, etchings, gloss etc). ...
  8. Replies
    62
    Views
    3,515

    In one of the pictures there is a circlip (the...

    In one of the pictures there is a circlip (the picture that says nut already removed). Could the circlip be holding everything in?

    John
  9. Replies
    18
    Views
    1,102

    Green paper shredder with half a dollar bill...

    Green paper shredder with half a dollar bill sticking out.
    Festool mini cash incinerator..

    (that being said I do really like my Festool Track Saw.)
  10. I would probably say no. The MSDS for the lamp...

    I would probably say no. The MSDS for the lamp oil indicates it is all normal alkanes (i.e. straight carbon chains of single bonds). Drying oils have some ability to chemically crosslink, and so...
  11. Replies
    1
    Views
    472

    Garage sale chuck parts

    Wandered over to a garage sale on the next street over from me, towards the end of the day and ended seeing a nice keyless drill chuck on a morse taper which I bought since the one I have for putting...
  12. Thread: Glue Gun

    by John Stankus
    Replies
    23
    Views
    1,312

    Another thing to look at is a solder paste...

    Another thing to look at is a solder paste dispenser. It is basically a pneumatic syringe setup. Saw some on Amazon for about $70.
    There are also things that look like little caulking guns that...
  13. Replies
    24
    Views
    1,503

    If you do this, mount it on one are of a Y...

    If you do this, mount it on one are of a Y connector(with the little valves) so you can vent the pressure. When you want to take it off.

    We put a whole house pressure regulator in and only...
  14. Replies
    19
    Views
    1,516

    I have this set of clowns running through the...

    I have this set of clowns running through the yard. I have to go on "turd patrol" before I mow.:mad:


    416319416320416321


    I'm open to suggestions on how to reroute them elsewheres. (I'm...
  15. Replies
    98
    Views
    7,375

    Any storage method will be a net consumer of...

    Any storage method will be a net consumer of energy overall. That is- no method of storage will be 100% efficient, therefore there are losses which are consumption of energy.

    Lets take the 70%...
  16. Replies
    98
    Views
    7,375

    On nuclear, the navy has some robust reactor...

    On nuclear, the navy has some robust reactor designs, and trains folks to run them too.

    There are several implementations of two level reservoirs for storage of renewables such as solar. Look up...
  17. Replies
    133
    Views
    22,582

    Sticky: I would like to register as well. John

    I would like to register as well.

    John
  18. https://www.amazon.com/U-FL-RP-SMA-Pigtail-Antenna...

    https://www.amazon.com/U-FL-RP-SMA-Pigtail-Antenna-Cable/dp/B005UWD0EG/ref=asc_df_B005UWD0EG/?tag=hyprod-20&linkCode=df0&hvadid=309833041189&hvpos=1o2&hvnetw=g&hvrand=11426569923890584277&hvpone=&hvpt...
  19. Replies
    31
    Views
    2,340

    List of denaturants from the US government ...

    List of denaturants from the US government

    Title 27 - Alcohol, Tobacco Products and Firearms. CHAPTER I - ALCOHOL AND TOBACCO TAX AND TRADE BUREAU, DEPARTMENT OF THE TREASURY. SUBCHAPTER A -...
  20. Replies
    31
    Views
    2,340

    Duda Energy is a one man shop providing supplies...

    Duda Energy is a one man shop providing supplies for the homebrew biodiesel community. The MSDS on their site has a different denaturants (http://www.dudadiesel.com/msds/ethanol.pdf) (I think...
  21. Replies
    14
    Views
    1,221

    Two benches... One to do the work on The...

    Two benches...
    One to do the work on

    The other to stack all the junk that accumulated on the first so you can do the work



    No flat surface is safe near me

    John
  22. https://woodworker.com/2-12x6-joiner-clamp-with-pa...

    https://woodworker.com/2-12x6-joiner-clamp-with-pads-mssu-114-608.asp

    Would these be them?
  23. Replies
    26
    Views
    2,460

    Lucchese are fabulous boots. My go to boots are...

    Lucchese are fabulous boots. My go to boots are Black Cherry Goat skin ropers (in 14D so I know the problems in finding sizes) If when you wear out the soles you get them resoled by Lucchese,...
  24. Replies
    20
    Views
    1,290

    I need to figure out how to convert my Dad's nail...

    I need to figure out how to convert my Dad's nail gun to fire only on trigger pull. Helped him with a couple sections of privacy fence and the bump fire scared the (expletive deleted) out of me. ...
  25. Workbench build questoin Bench bolts/Cross dowel nuts layout

    I have been finally working on the legs of my workbench build (my projects move in geologic time...start of the top was three or four years ago :o )

    Two questions
    1. I have the bench bolts from...
Results 1 to 25 of 306
Page 1 of 13 1 2 3 4