Yes I was thinking of making some sort of shower curtain arrangement, if nothing else but to keep the walls and equipment clean. The front facing to the street would be open, maybe the back too so I...
Type: Posts; User: jeff friedman; Keyword(s):
Yes I was thinking of making some sort of shower curtain arrangement, if nothing else but to keep the walls and equipment clean. The front facing to the street would be open, maybe the back too so I...
I am setting up a three car garage shop to build cabinets. I will be spraying catalyzed conversion varnish’s. The main use of the compressor will he for this. What is a reasonable size compressor to...
I picked up one of these used for $700. It was an impulse buy after building a kitchen of raised panel doors on a home made router table. Has anyone experience with these? I read that it can take...
Go to the grizzly site and take a look at these two 3hp cabinet saw models G0651 vs G1023RLX. Need the 50 inch plus fence since i will be making cabinet boxes in a semi pro / hobby output. What is...
In the world of semi professional woodworking tools such as cabinet saws or planers I have noticed the Grizzly’s equivalent tend to be a few hundred cheaper that the competition, such as Jet,...
Got it . Thanks
Ok that is great for the cut list for panels. What about actual cabinet drawings. I hear. About sketch up? Is that the best?
All - I have seen some cabinet saws advertising 220 v 3 hp and others 240 v up. Do I need to wire my shop differently or does both get treated the same?
All - what is the best free cabinet software along with cut list optimization software?
Yes, distance from front of table to blade is important when cross cutting door panel glue ups. Are they all about the same for the cabinet saws? On some that dimension is not listed.
Thanks for the tip on the Saw Stop. I just assumed that i would be giving up on actual saw for the stopping feature. I have used an Altendorf in a prior life in a production setting. I agree that if...
I enjoy milling 4/4 rough stock on my planer and ripping for face frames and door panel glue ups and style and rail material. Most of the time I can end up with 7/8 material finished. I like this...
Can someone point me to good articles comparing the leading cabinet saws - Jet, Grizzly, Delta, Shop Fox, etc.? I am looking for a new saw, for cutting a lot of cabinet boxes, along with face frame...
is the only purpose of a magnetic switch to prevent the saw from turning back on after a power outage? Meaning can i just simply replace with a normal 220V electrical switch?
I bought an older Rockwell Unisaw. The starter switch was not working well (sticking in the on position). I purchased what i thought was a direct replacement as shown in the photos and it turned out...
I purchased a new switch since my last one was not very responsive - trouble turning on an off. Also a humming coming from the switch when off. A couple questions. One, where to attach the red ,...
No comments?
I found this article on motors that appear to be “braking” :https://www.finewoodworking.com/forum/noisy-brake-in-tablesaw-motor
https://youtu.be/XHhRBF-0dcg
OK I post two more videos. One showing the free rotation of the blade with the belts removed. And the other showing the power on of the motor without belts. Tell me what you think.
...
I will take the table off tomorrow, remove the belts, and see how to motor sounds without anything attached. I will also ensure the arbor plate is positioned out far enough not to be rubbing. I think...
Ok public now. I guess I am questioning how freely the blade should rotate. It’s connected by three belts to the motor at some tension greater than zero and should put some resistance on the motor....
ok, try now and tell me your thoughts:
https://youtu.be/JQGOxMBLK3o
Trying pasting that link into your browser:
https://youtu.be/JQGOxMBLK3o
what is meant by a "high/low design"?