Thanks again to all of you. If i like the way the Laguna cuts i will keep it.
Type: Posts; User: Robert Weinstein; Keyword(s):
Thanks again to all of you. If i like the way the Laguna cuts i will keep it.
thanks again, 220 is currently out of the question. not aware of the square attachment for the Unifence.
thanks to all of you. Much help.
I have been using an approximately 30 year old Delta contractor saw (model 34-445) with a Delta Unifence for about three years. The Delta has a 66" table (pieces added by a previous owner) with 46"...
Reopening this older thread.
I want to build a machinists chest and will need hardware. Is there an alternate to Gerstner?
Thx
Thanks Tony, this may be another way to go.
Thanks Lee. Yes, 3/4 rails and stiles. I am reluctant to do a lap joint yet, so i hope using tongue and groove for attachment will be ok. Understand the bottom and have learned that and other rabbet...
Just joined forum, although have gotten a lot of good information previously and I thank all of you. I would classify myself as an advanced beginner.
Wanting to build the pictured below steamer...