If it is a rental do the minimum to get it rented. Save the real upgrades until you are ready to sell. White paint is good. It is easy to touch up. "A nice new laminate counter top will be cheaper,...
Type: Posts; User: Chuck Werts; Keyword(s):
If it is a rental do the minimum to get it rented. Save the real upgrades until you are ready to sell. White paint is good. It is easy to touch up. "A nice new laminate counter top will be cheaper,...
Maybe a pivot hinge?
http://extranet.assaabloydss.com/library/catalogs/RIXSON/pdf/6-Pivots_and_Pivot_Sets.pdf
Maybe you could get some tubular steel from a scrap yard and wrap that for a post.
I am new to woodworking and all I have to work with is my dad's old shopsmith. I have been saving for a good table saw but threads like this really make me consider a track saw system. I seems like...
I went to a local truss manufacturer and talked to the engineer. Paid him $100.00 to draw them up as a side job.
Yes, wood movement probably would be an issue. I should have thought about that. As long as it is sitting on plywood and not suspended I think you will be fine with any of the options on this thread....
I don't know that I would trust gluing end grain. Can you laminate a piece of plywood to the bottom in such a way that it can’t be seen? Maybe just a piece down the middle that can be recessed into...
According to the original study, this does not include people hurt at work. I can tell you from experience that many people work for companies that require a post accident drug test. People who use...
I have the older model. I have to reach under the table to set the height and to lock the spindle. It's no big deal. Once you do it a few times your hand goes right to it.
you can reach under the table and push the lock by hand.
they give you a 1/2 rubber grommet to put in the bottom of the collet.
I have the T&G set and the shaker raised panel set. I never made anything with a router before and it was easy to use both sets. They all line up just like the demo. I didn't spend the money for the...
I would put a 1/4 by 1 1/4 fender washer or whatever size hits the lip of the satndard between the standard and the wall and use some longer screws. It seems likee t would be hard to make a spacer...
I think the key is thermal overload protection. A motor circuit has either a moter starter with thermal overloads to protect the motor or an internal overload in the motor leaving the circuit breaker...
I have to order a filter for the dust collector anyway. If my friend comes through with a blower before I get the DC and the canister put together I will rig it up and invite some friends over for a...
You might have to wait until next winter. I am hoping it will be warm enough in the next few weeks to work with the garage door open. Big fan, open garage door, no problems.:)
I think it will still be affordable. If I mount the fan directly to the filter with a plywood adapter ring. Like one of those little single bag dust collectors in reverse. I should be able to do it...
What type of fan do you think would work? I was considering a 1600 CFM attic fan, but I am not sure it will work with the fiter because I think they are made to run with no resistance(filter).
I think Brad is correct. Back feed the breaker and there should be a retaining clip available.
I think the size would be an advantage- more surface area. Maybe not for some, but my ceiling is 13 ft high(I have bikes hanging up there). As far as cost I think it would be a one time expense...
First let me say, I have been lurking on this forum for a long time and you have given me some great tips. In fact, I am about to buy the HF dust collector and the Wynn filter. That led me to this...