Search:

When i lived in the Houston area the humidity was so bad that I would have to treat my cast iron tops two or three times a year. I always used maroon Scotchbrite pads on a random orbit sander to...

In the past couple of months I have ordered and received a rebuild kit for the regulator on my Dewalt compressor and table trunnions for my Delta band saw from them. I ordered the parts within hours...

I have one just like that on my bandsaw too. I just use regular rough service incandescent light bulbs. Best I can remember I have not had to replace the bulb in in over 5 years and the light sees...

last as long?..........probably not but I have not noticed the difference myself. And it only takes a few seconds to remedy the situation if I dull a bit in the middle of a project.
...

I keep my Drill Doctor near the drill press and use it regularly. I have known a couple of people who could do a better job of sharpening bits on a grinder than I can on the DD but I am not one of...

Thanks for all the replies. I have decided to continue on with the Dewalt job site saw until the time comes that I can or am willing to commit to spending enough to make a significant difference. I...

I have checked that quite regularly for the last few months. If I missed the $500 cabinet saw, please, point it out to me.

That's mighty close. I'm about 55 miles from San Antonio and about 95 miles from Austin (I prefer not to go there).

Thanks, for the replies everybody.

Back 10 years ago when I got my Dewalt 744 I was a full time RV'er managing a campground and my shop was one of those 10' x 20' carport tents. My old cast iron...

Hello, I'm new here, and looking for some opinions on lower priced table saws.

I have owned a Dewalt DW744 jobsite table saw for about 10 years or so. At the time a jobsite saw was the best...