Search:

Some vendors will register a car for you for a nominal fee. AAA Auto Club, by way of example, will register your car for free as part of your membership.

James, you might want to peruse this 2023 thread on the same subject

https://sawmillcreek.org/showthread.php?305794-Festool-Mortising-Template/page2&p=3280115


I don't have any Festool tools...

I paid for a few years, but basically went back 20 years and copied every article that was remotely interesting and organized them by subject matter. That process took me weeks to complete.

Rick said the same thing I need, but better. +1

So based on the information provided by Cory, the OP, it is the drawer front which is flexing, understandable I guess since it is so wide. As others have posted, having a drawer front of 3/4 stock...

I guess I am not understanding how the sides of the drawer would flex if the corner joints (dovetail, rabbet, finger joint, etc) were properly made. The bottoms usually provide little or no overall...

I'm going to go a different direction here. I think most of the strength in an edge joint comes with the glue, not the dowels, which while adding some strength, are used mainly for alignment. If...

Cedar and stain.

Vinegar solution 1:4

In my lifetime, nothing has ever gone down in price. I remember gas for 30 cents a gallon. I'm not sure what the point of this thread is.

When I was a framing carpenter, the most dangerous and most common dangerous tool was . . . .

The hammer.

No joke, the straight claw ones hit guys in the head. The 22oz waffle headed ones...

My doctor said it doesn't work. I just live with the disease and once a year have my podiatrist cut away the infected nails, which is actually fairly painful.

I've used System 3 for more than a decade and have never noticed much of a difference when varying the resin to hardener ratio. Perhaps it might cure faster with more hardener, I don't know, I've...

I still doubt they are truly sharp inside and out. Sharpening a hollow chisel mortising bit is more than a couple swipes on the outside with a diamond stone.

I do two sharpening sessions on the...

Did the owner add a bathroom?

Later, if they decide to do add a shower, update a service panel, or do something else that requires a permit, and the inspector notices an additional un-permitted...

I have never had any problem with a similar (Delta) mortiser. I suspect your bits are not sharp. Often, they are simply not honed fine enough out of the box.

For the outer bit, the chisel, the...

I agree. A small bedside or coffee table is a good way to start. This table was a beginner project where I went to woodworking school in Waco, Texas: ...

Well, if it doesn't work, then it has to be sold "for parts." I doubt I would pay much over $50. It's 3 phase which is incompatible with my shop, so I would probably pass on this.

How does the Fastcap stick work? It seems similar to any push stick.

I don't think this was the saw's fault. It does sound like perhaps you were in a hurry and very comfortable with the cut and...

We concluded that the Advantage Program has a big advantage, but if one doesn't like it, it nearly impossible to switch back as pointed out above. So we declined the Advantage Program.

Yes, I need the tools to be stored under a work surface at about 35" so a 44" cabinet, while nice would waste space.

I have a 6 foot run of 40 year old metal Craftsman Tool Drawers-Tool Chests under a laminate top, which has served me well. It is 33" high plus the top, I got to order custom drawer sizes (I like 2"...

I'd ask the manufacturer of the vinyl flooring for its recommendation.

What John TenEyck said.

Nothing wrong with Kreig pocket hole joinery.