Search:

Thanks for the advice. You saved me a hundred bucks for a ew faceplate.

Good evening. I will be turning a couple of pieces of wood that measure 17" diameter, 27" length and 56" in circumference. I'd guess each piece weighs in at 70-90 pounds. Initially, I was undecided...

Good evening. I am interested in hearing from anyone who may have purchased and used any of the new(?) Hunter Tools. I am especially interested in the chisel for hollow forms and end grain that uses...

Geez, I'm mightly embarassed to make this post. I incorrectly wired the plug. I posted a message on Friday that I was having trouble getting my new 21" Grizzly BS to operate. The post generated a...

Folks..I received a personal message from one of the members and sent the response below. Also, I retract my statement about not buying another Grizzly tool. It was a regretful rush to judgement...

Mr. Jones..I apologize if I have violated a protocal of the website. My intent was not to rant but use the same calm approach I did with the TAs. Looks like I went over board. I have not had this...

I'm glad to see that some of my colleagues are as disappointed as I am about this. The specs on the motor are:

Type-TEFC Capacitor-STart Iduction, 3 HP, SIngle-phase/220 V, 15 Amp, 60 Hertz/1725...

I recently purchased a Griz GO566 21" Bandsaw. Tool of a lifetime for me. I've been a professional/hobbist woodworker for nearly 40 of my 62 years. I learned early on to save my money and buy the...

In addition to all the good advice received and given; I tear my sandpaper into rectangular sheets and keep them by grade in one of those flat plastic tackle boxes that have the moveable dividers. ...

Thanks Jim. My bench, including the base, is very similiar to yours, including the nics, burns and notches. The working side edge is especially rough. Also, there is a solid sheet of 2/4 maple over...

I was thinking about that, Steve. I'm not sure what it entails. Probably disassemble the vise, preplace the runners (?) on each side, resurface and put a metal faceplate on the moveable end. ...

Happy New Year folks. I have a very old wood workers bench. Hardrock maple, wooden screws on both front and end vises. I purchased the bench about 40 years ago from a fellow in his 80's who said...

Folks, I cannot begin to thank you all for your invaluable comments and expertise. I've printed the thread and will refer to it again on many of the important decisions I'll need to make as I enter...

Just purchased a PM66 and now I need to purchase blade(s). The selection is a bit overwhelming. This is the first TS I've owned and will be doing general cabinetry. Tool crib has a Freud 3 blade...

Posted this at Woodnet and got a couple of helpful responses. Thought I'd try here also. Thanks. THP

I'm looking to buy a 20" bandsaw for resawing and roughing bowl blanks. Looked at all the...