Search:

Type: Posts; User: Tim Boettcher; Keyword(s):

Search: Search took 0.00 seconds.

  1. Replies
    4
    Views
    290

    NFPA664 compliant Dust Collector

    I still haven't pulled the trigger on a dust collector, and at the suggestion of Clearvue, I contacted a Nordfab rep about getting a duct design.
    Basically he shut me down saying Clearvue cyclones...
  2. Replies
    11
    Views
    1,041

    Electrical in Workshop

    My shop currently only has two 30Amp 220v receptacles (single circuit) in the center of a 40x40 area, and a couple by the panel, and one in the corner.
    Most of the equipment will be in the center...
  3. Replies
    14
    Views
    805

    I'll give it another look, and get Norfab to get...

    I'll give it another look, and get Norfab to get me a design and quote.
    When I looked at it last the seemed just about any component was in the hundreds.
    I had budgeted like $2k for ducting, but...
  4. Replies
    14
    Views
    805

    Thanks guys for all the input...

    Thanks guys for all the input...
  5. Replies
    14
    Views
    805

    Max main trunk run would be the 50' diagonal.. ...

    Max main trunk run would be the 50' diagonal..
    I don't envision much else other than a planer.. and I know they are the worst.
    I don't do that much rough lumber yet.. so to save costs, skipping...
  6. Replies
    6
    Views
    467

    The area is 40' x 40' with sloping ceiling...

    The area is 40' x 40' with sloping ceiling ranging from 18' to 10'.
    I was just doing using the calculation based on the air volume - hoping I didn't make a mistake.
    I thought better overkill,...
  7. Replies
    14
    Views
    805

    Ducting for DC

    Seems lots of good discussion about Dust Collection, so I'll ask too.

    Looking at the Clear Vue Pentz EF5 with an 8" intake.
    The Idea would be to run the 30' main line at 8", branches at 6", and...
  8. Replies
    6
    Views
    467

    Air Filtration Air Flow

    I'm getting two Jet AFS-2000 1700CFM Air Filtration System units for my 40 x 40 shop.
    Question on placement...414408

    Should they be figure 8 or circular? (See attached)

    I'm feeling Option A,...
  9. Replies
    6
    Views
    480

    HEPA Air Filtration for shop

    I'm am looking for a true HEPA (sub 1 micron) Air filtration system which would support a 40 x 40 shop @ 6x/hr?
    I see lots of options which get the right CFM, but not many with the filtration I'm...
  10. Replies
    45
    Views
    7,462

    Thanks!

    Thanks Guys for all your responses.. I had a lot of reading to do when I came back today.

    Here is more clarifications, to some of the questions.
    * This is hobby.. i.e. after work, or weekend type...
  11. Replies
    45
    Views
    7,462

    Best 25k or 50k Workshop?

    Looking to invest $25k to 50k in my workshop (i.e. buy new most likely)

    Have about 20x40' to work with.

    My goal will be to mostly make household furniture, built-ins, some cabinetry etc.

    I...
Results 1 to 11 of 11