Search:

Type: Posts; User: Geoffrey Keating; Keyword(s):

Search: Search took 0.00 seconds.

  1. Replies
    14
    Views
    1,435

    Got it

    Thanks to all for the advice, etc...

    I finally got it within factory tolerances. Unfortunately, I don't have any advice for fixing the problem other than don't take your top off or if you do make...
  2. Replies
    14
    Views
    1,435

    Yeah, the top is pretty flexible. When I set it...

    Yeah, the top is pretty flexible. When I set it on my bench it gets a lot flatter than when it's on the saw.

    I'm still not having any luck, as it seems to crown in the center. Once I get it...
  3. Replies
    14
    Views
    1,435

    Jim, thanks for pointing me to the Grizzly...

    Jim, thanks for pointing me to the Grizzly manual. It has about ten times the info that the PM2000 manual has.
  4. Replies
    14
    Views
    1,435

    Gentlemen, Thanks so much for the responses. ...

    Gentlemen,

    Thanks so much for the responses. The magnet is a great idea (didn't think of that).

    Jamie, I read your linked thread (excellent info). Where did you buy your shim(s) by the way? ...
  5. Replies
    14
    Views
    1,435

    Question about TS top shims

    Hello all,

    I read the board quite a bit but post rarely. Usually when I have a problem;). Right now I'm having a problem with the shims under the top of my TS top and any suggestions would be...
  6. Question about Delta dust collector

    Hello all,

    I've got a Delta 1.5HP dust collector. It is about a month old and has worked great until now. This morning I emptied the collection bag and shook out the filter bag. When I hooked...
  7. Replies
    9
    Views
    1,519

    Juan, I use the LV low-angle jack for almost...

    Juan,

    I use the LV low-angle jack for almost everything. Flattening, jointing edges, shooting miters, you name it. It works great.

    Their bevel-up smoother is also "amazing" (reversing...
Results 1 to 7 of 7