Search:

aha!! that's a great idea. for some reason i was just drawing a blank. probably because i moved recently and haven't been in the shop for about a year. this is my first project in my new place. I...

I am making an oak counter and will be installing a cooktop flush. The corners of the cooktop have a 3/8" radius. The rabbet needs to be 1/2" wide to support the lip of the cooktop. To get a...

Looks straight out of Little House on the Prairie

Thank you. I used 1/2 ply as a substrate for the veneer. So the field is a little thinner than the frame. It’s recessed on the underside. If I ever make it into a table that lip underneath will make...

Finished a chess board this weekend that i've been working on since after Christmas. Wenge and curly maple squares, Brazilian cherry frame and ebony, lignum vitae for the boarder. I use General...

I finished up a chess board. wenge/curly maple, brazilian cherry frame w ebony and lignum vitae boarder. finished with general finishes arm-r-seal semi gloss, + a couple coats of wax. bought the...

My friend said he wanted it 5 inches shorter, but i told him to think about that because that's a lot to be off from the original height, which we tested before hand. I think if i rabbeted the top...

Thanks for the input so far. the large top box section is just held in place by gravity. It lifts off and as i recall is about 3 inches proud of the top of the rails it rests inside of (4 inches...

I built this about a year ago for a friend. We experimented with the height for him but after prolonged use he feels its too tall. It is made of Brazilian Cherry. Joints are M&T and everything is...

I've built a bathrooms worth of cabinets out of it and am now building a standing desk and side table for a friend. never had a problem with my DeWalt 635 until one board i used for my current...

i'm building my first Humidor and I was wondering if I should apply a sealer to the inside prior to fitting the liner. i veneered cherry to solid cedar and will construct the liner and fit that. i...

I have that set up and the 1 inch blade (i have a timberwolf) works great. don't have a 3/4 for comparison but i agree it can be a bear to get it on, but once its there it works fine and for me, i...

+1. been very happy with mine. put a lot of jatoba through it and never had any issues.

I used it in a bathroom remodel. built all the cabinets and molding out of it. if you try to take too much off at one time with the router it will chip out. I took about 5 passes on the raised...

Has anyone replaced the brushes in this kind of drill and if so how? are there instructions somewhere? I called the service center and they sell the brushes for about 3.50 each but have a $25...

I use a Shop Fox base under my Grizzly jointer and it stays put when i want it to and moves easily when i need it to.

that's awesome!!!

Has anyone use those jointer knive hones that are available and if so do they work well or are they a waste of money?

Woodworkers supply sells one called a Honemate.

I'm building new cabinery for my bathroom and plan on building a floor to ceiling pantry cabinet that will be free standing (and screwed to the wall). the cabinet height will be about 99 inches.
...