Could i just cut a few blocks that are 1/2" and screw some metal into them on the sides and butt them up into the corner of the bed that way i can still set in the sheet squarely and that will give...
Type: Posts; User: Dylan Hall; Keyword(s):
Could i just cut a few blocks that are 1/2" and screw some metal into them on the sides and butt them up into the corner of the bed that way i can still set in the sheet squarely and that will give...
So after running some tests with different dpi and speeds i took off the paper from the bottom also and i was noticing that the "chip" look on bottom was whenever it hit one of the honeycombs as it...
I overlooked that when i took the screenshot. We do have it set to vector (was wondering if cutting was the same settings? I will attach a picture). I will also turn the air down because i do hear it...
We have slowed it down to 1.5% speed with the 1/2" acrylic. now the air assist pressure i am not sure about we have an electric fan motor that just pulls the fumes and debris out. Is there a way to...
So sand it down with a fine grit and then what kind of gas? Does it matter if i am using map gas torch?
I am running the vector cut out at 1.5% speed, should it usually be slower than that? I am using a 4" H laser lens and on my vector cuts it is 100 power 1.5 speed 1 pass and dpi 1000
Any speed over 2% will either need a second pass to cut through the 1/2" and/or give an even worse finish to the sides. I made a comment right after i posted saying i use the red line as vector and...
More info. I am actually using the red line on vector (forgot to change it) and it is cast acrylic.
I made an account on here because everyone seems very helpful and i am hoping to get some help myself. We have a Gravograph LS900 80watt laser that we are using to cut out 1/8" 1/4" and 1/2" acrylic....