All very good points, especially the one about your son!
Type: Posts; User: Craig Shipman; Keyword(s):
All very good points, especially the one about your son!
I just drove 3 hours to the Columbus show and it was a waste of time. The shows that used to be in Detroit were huge, at least 10 times larger (or so they seemed). The one in Columbus was at the Ohio...
Great article, Thanks Chris. Now I am rethinking it :)
Great article! I might do the Bridle.
I want to thank all of you for your comments. At the end of the day, I decided to go the traditional route using a closed mortise. I found on the Internet that mortise and tenon joints have been...
Cameron is correct. The mortise width is ½ inch. If I use a 3/4” setback, the long face (they will be mitered in the center so one face will have more surface area than the other) of the mortise...
I am building a cherry dining room table that is 84.5” x 34.5”. The legs are 3 ½ in.² and will be turned. The rails are 7/8”x 4”. I am at the point of mortising the legs. I am doing a traditional...
Thank you Ralph. I have been suspicious of the nut but not having a new one I had nothing to compare it to. I'll check with Veritas and see if they have any parts laying around yet. If they don't do...
I entered this previously but I think it used the wrong forum. I have a Tucker Vice that I purchased new in the 90s. It has worked great however recently I'm not able to tighten the vice enough to...
I have a Tucker Vice that I purchased new in the late 90s. The vice has been great up until recently. Everything works fine until I get to the last couple terms of tightening. As the vice gets...
I have what is probably an out-of-the-box question. I am a woodworker but not a boat builder. For years I have thought about building what would actually be a sculptural piece for over the couch in...