Search:

Type: Posts; User: Frank Pratt; Keyword(s):

Page 1 of 20 1 2 3 4

Search: Search took 0.06 seconds.

  1. Replies
    4
    Views
    372

    Everything about it is very nice; design, grain...

    Everything about it is very nice; design, grain selection, finish. Well done.
  2. Replies
    23
    Views
    1,137

    Same here. After a few years the floor reaches a...

    Same here. After a few years the floor reaches a steady state of stains & paint splatters & never seems to get any worse. It is never slippery and even though it doesn't sweep quite as easily as more...
  3. I've used 15 year old Klingspor belts and never...

    I've used 15 year old Klingspor belts and never had one break. My current stock of belts are anywhere from about 8 - 15 years old and I've never had one break. They are stored in a dark drawer in my...
  4. Replies
    8
    Views
    404

    The spiral is much stiffer for a given gauge. I...

    The spiral is much stiffer for a given gauge. I could have easily used 30 gauge without danger of collapse, but nobody carries it.
  5. Replies
    8
    Views
    404

    I used 26 ga spiral, 8", 6" and 4". It's very...

    I used 26 ga spiral, 8", 6" and 4". It's very sturdy. They make it with the bumps on the seams on the inside or the outside. You want the stuff with the bumps on the outside and smooth on the inside....
  6. Replies
    28
    Views
    1,441

    It's a whole other matter in a commercial...

    It's a whole other matter in a commercial building where the cables have corroded. It almost always involves excavating the cables at 1 or more placed along the length of the run so they can get the...
  7. Replies
    28
    Views
    1,441

    If you do drill into a post tension cable and...

    If you do drill into a post tension cable and break it, you'll know right away. Post tension slabs just aren't used anymore in these parts because repairs for corrosion, when (not if) it happens, are...
  8. Replies
    28
    Views
    1,441

    By the time you line the return air with 1"...

    By the time you line the return air with 1" acoustic duct liner (definitely want to do that) you will not have a lot of cross sectional area. With that many bends, I would want to have at least 2X...
  9. Will your sanitary sewer (there's an oxymoron)...

    Will your sanitary sewer (there's an oxymoron) not handle the back flush? 100 gallons isn't that much.
  10. Replies
    6
    Views
    1,492

    I've heard a lot of really good things about...

    I've heard a lot of really good things about Harvey machinery lately. I wish they had them in stores so a person could actually lay hands on them. @Doug Walls what features do they have that SawStop...
  11. I built a 'sound proof' closet for my compressor...

    I built a 'sound proof' closet for my compressor and 5 HP dust collector along with some shelves for storage. It has a cyclone and a HEPA filter. No dust at all, like not even a trace. As with Paul,...
  12. Replies
    14
    Views
    1,210

    It doesn't hurt, but it's not needed. Pros never...

    It doesn't hurt, but it's not needed. Pros never do it.
  13. Replies
    41
    Views
    3,454

    Some more comments I'll add.

    Some more comments I'll add.
  14. Replies
    29
    Views
    2,189

    Right you are! That surprised me. It also...

    Right you are! That surprised me. It also surprised me how much more expensive they are now than when I bought.
  15. Replies
    41
    Views
    3,454

    Lots of good advice here. I'll just add a few...

    Lots of good advice here. I'll just add a few comments.
  16. Replies
    29
    Views
    2,189

    Most who have a 1.75 HP will tell you it's...

    Most who have a 1.75 HP will tell you it's plenty. I've had a 1.75 HP (Jet) and a 3 HP. You can get by with the smaller motor, but the bigger one is that much better. If you are considering...
  17. Replies
    11
    Views
    681

    My Honda has such crappy GPS that I never use it....

    My Honda has such crappy GPS that I never use it. The voice directions come through on the car sound system fine when using the phone GPS though.
  18. Replies
    41
    Views
    3,454

    I agree. Use the area near the ceiling for...

    I agree. Use the area near the ceiling for horizontal runs & just drop straight down to outlets. It makes changes easier and the pipe doesn't get in the way of other fixtures you may want to wall...
  19. Yikes! Hard to believe someone would do that.

    Yikes! Hard to believe someone would do that.
  20. Replies
    41
    Views
    3,454

    You should check code on that. Here, you cannot...

    You should check code on that. Here, you cannot run non-metallic cable on a metal surface without providing insulated spacers. And cutting the backs out of the boxes will certainly void the...
  21. Replies
    41
    Views
    3,454

    No, the conduit can serve as ground, but that's a...

    No, the conduit can serve as ground, but that's a practice that is often frowned upon by engineers (for good reason). If you do run a ground wire, it must be sized for the largest circuit in the...
  22. Replies
    41
    Views
    3,454

    EMT hands down looks best for surface work. But...

    EMT hands down looks best for surface work. But you have to take some time to learn how to do the bending. Elbows are easy. It's the offsets, kicks and saddles that are a lot harder to have look good.
  23. Replies
    21
    Views
    1,316

    Sorry, the stain's at home and I'm not. It is a...

    Sorry, the stain's at home and I'm not. It is a fairly heavily pigmented stain that, depending on how much it's rubbed back, can give it a very white washed or pickled look to just slightly pickled....
  24. Replies
    21
    Views
    1,316

    It may be the way the photo shows, but I'm...

    It may be the way the photo shows, but I'm convinced that there is more than just a water white clear finish on it. Even a colorless finish warms the wood up a bit, even though it's not adding any...
  25. Replies
    2
    Views
    579

    Sorry, I can't help with that. But you should...

    Sorry, I can't help with that. But you should give Paypal a shout in case there is a deadline for taking action on it.
Results 1 to 25 of 500
Page 1 of 20 1 2 3 4