Hi Chris,
I just take the removed cheek of the tenon and glue it back on, then recut.
Tom
Type: Posts; User: tom blankenship; Keyword(s):
Hi Chris,
I just take the removed cheek of the tenon and glue it back on, then recut.
Tom
Hello Paul,
I acquired a multimeter.
The prongs of the supply cord plug show continuity withtheir terminations in the switch box.
The switch has four wires attached; a white wire and a...
Greetings Folks,
I have a Delta 14-651 mortiser. It was used it successfully yesterday. Today it will not turn on, no sound, no nothing. I verified that the power source was active.
The switch...
I have a question about a table top glue-up.
I glued (using Titebond II) and clamped two boards together for a small table top. As I tightened the clamps I noticed that a half inch long portion...
I ordered two, but they are already backordered. Only $5 to have it monogramed with your initials!
Congratulations Mark,
I also aspire to obtain a PCS Sawstop. I hope you will tell us about your experience with receiving it and it's setup and performance. While the saw has a fine reputation, I...
Thanks to each of you for responding!
Kent........no, you are not missing anything. I did clamp a board across the front as you advise, with alignment accomplished. But the drawer is too long to...
No, the top is not yet on the table.
Greetings,
I am fitting a small drawer (about 11x10x3 inches) into a side table. It is a flush fit (no false front) drawer on wooden runners. The reveal is fine but I am struggling with getting...
In my experience stupidity is painful. I endure a lot of pain.
I wish you rapid healing.
tom
Greetings,
I would appreciate current opinions on these gauges. A search indicates that some users find that the magnets on the wr365 do not hold the gauge adequately in vertical position.
I...
Hello Richard,
I apologize to you for my meager attempt at humor. I felt that you had already received several good responses to your question. Your question is one that I struggle with as well....
I consistently keep all cut deviations within 2 angstroms per parsec. :D
tom
Thank you !!
Thanks to all of you for the insight!
tom
So, how do you keep sawdust off the Harleys?
Beautiful restoration on the mortiser!
tom
I am trying to recall the sequence of edge jointing boards for a table top so that their mating edges match precisely, allowing for any imprecision in the perpendicularity of the fence.
Start with...
Check the splitter behind the blade. If it is angled it will move the wood away from the intended cut line.
tom
What's a Henway?
Probably 4 or 5 pounds.
Yep, I detect a deep and visceral sucking sound in the distance.
Good for you!!
tom
I bought a similar unisaw three weeks ago off Craigslist (Sacramento). Built in 1989, Jetlock fence, 3 hp, great condition, for $500. It was used by a hobbiest.
Greg,
I too find that I am more comfortable with the band saw fence toward the right side, as with the table saw. I am right handed.
tom
Greetings,
I have found a used Unisaw, model 34-802 for sale. The saw seems to be in very good original condition.
3 hp, single phase motor (Delta). Delta fence, but is not a Unifence (does...
My Makita 6227 12v drill batteries no longer take a charge. Have any of you had good experience with having similar batteries rebuilt?
Thanks in advance.
tom
Greetings,
I am attempting to tune up my Craftsman contractor table saw. It is a late 80s version. I have installed a Forrest Woodworker II blade.
My best adjustment leaves .003 inches...