Search:

I am not sure if this is the correct place to ask this question, but I am trying to identify an old tool that was given to me.

I found the video I was looking for on the Leigh website in chapter 14 of the D4R Pro Complete Video.
Thanks to everyone for the replies.

Perhaps I am doing something wrong. I think I am following the instructions but I must be missing something.

Has anyone seen a good video on making asymmetrical dovetails with a Leigh DR4 jig? I want to make boxes where the bottom tail is much wider than the others. It seems that I need to use both sides of...

A lot of good information here guys, thanks. It seems that maybe leaving the stock extra wide and then ripping it after the profile is cut might be the easiest way for small runs. I like the idea of...

Here is the setup I used to make the profile in the picture. The problem is that there is nothing for the top of the profile to rest against the fence.479834479835

This is the setup I have been using but it only works if the profile leaves full thickness top and bottom. I can leave stock oversize and cut to size after profiling but my stock was not wide enough...

The difference I see in these videos is the stock is laying flat and the profile cut is on the edge of the stock so there is room to run the feeder on the top of the stock. I am Making 3 1/2" crown...

I must be missing somhere because I do not see how my feeder can straddle the cutterhead. I would really like to see some pictures of the setuup. I have done a search on the internet but have not...

I want to set up an outboard fence for my shaper to make some moldings. This is the first I have done this but I am aware of the dangers of kickback. I plan to use my power feeder but am not sure how...