Search:

Type: Posts; User: Bill Dufour; Keyword(s):

Page 1 of 20 1 2 3 4

Search: Search took 0.05 seconds.

  1. Replies
    45
    Views
    1,905

    I like to use aluminum foil for paint masking. ...

    I like to use aluminum foil for paint masking. Holds nicely to curves and self holds when crumpled around a feature.
    Bil lD
  2. Replies
    7
    Views
    168

    I think he means delta/rockwell 14" BS

    I think he means delta/rockwell 14" BS
  3. 100Hp tells me they are thinking 50Hp or more...

    100Hp tells me they are thinking 50Hp or more output power motor.
    Bil lD
  4. Replies
    2
    Views
    135

    is it a strap clamp for the metal banding on...

    is it a strap clamp for the metal banding on crates?
  5. Replies
    38
    Views
    631

    Location? I am guessing you are talking...

    Location? I am guessing you are talking fahrenheiht?
  6. Replies
    38
    Views
    631

    36' is nothing to the source of unlimited amps so...

    36' is nothing to the source of unlimited amps so voltage drop is not a problem due to long wire runs.
    Bill D
  7. Replies
    18
    Views
    653

    Being designed in California I would assume it...

    Being designed in California I would assume it would be designed for deep snow, much deeper then Michigan ever gets. Detroit only averages 33 inches of snow. INCHEs not feet!
    Bill D
  8. A quality tank has the drain port flush to the...

    A quality tank has the drain port flush to the tank bottom or a dip tube down to the bottom inside the tank.
    Bil lD
  9. Replies
    38
    Views
    631

    You need to convert to 240 volts or pull new 120...

    You need to convert to 240 volts or pull new 120 volt wire to carry 30 amps at 120 V. The breaker and wire is fine you are just at the limits.
    How far from the service entrance does the wire run? ...
  10. Looks easy enough to pull the bearing. Just make...

    Looks easy enough to pull the bearing. Just make sure to pull only on the inner race or you will get Brinnelling and destroy the bearing. Same on the install. I would make some kind of split ring...
  11. Replies
    25
    Views
    630

    CL inland Empire has a 3Hp Murphy Roger cyclone...

    CL inland Empire has a 3Hp Murphy Roger cyclone systm for $850 today.
    It has a "Blue Tornado"? cyclone.
    Only problem ? is it is three phase so you would need a VFD. But, that allows a slow start...
  12. Replies
    25
    Views
    630

    Watch Cl for a used unit. The only thing that...

    Watch Cl for a used unit. The only thing that wears out is the motor bearings and maybe the filter bag. You probably want a better filter anyway. In your climate I would vent outside with no...
  13. Replies
    19
    Views
    453

    Also I would think blowing into a big bush or...

    Also I would think blowing into a big bush or group of trees would help soak up the sound. Something like a mature redwood grove with bark 2' thick is very quiet. Of course that may take a few...
  14. P&H ? More words to make the minimum count ...

    P&H ?

    More words to make the minimum count are down here to be ignored
  15. Reduce max pressure to 100 PSi. reduce motor...

    Reduce max pressure to 100 PSi. reduce motor pulley diameter by 1/4? Put a muffler on the intake. Some folks use a new motorcycle muffler. I used a old oil bath air cleaner.
    Bill D

    I bet a...
  16. I have always wondered about the point of...

    I have always wondered about the point of galvanized pipe used inside. Buried in dirt the zinc prevents exterior rust. But the inside, which is wet all the time, has no zinc whatsoever.
    Bil lD
  17. Replies
    11
    Views
    225

    I would at least try a new start cap and blow...

    I would at least try a new start cap and blow dust out of the centrifugal switch. A start cap off ebay would be under $5.00. hardest part will be reading the numbers on the old cap. If illegible...
  18. Replies
    30
    Views
    1,041

    A big rotating mass like that will generate back...

    A big rotating mass like that will generate back EMF for a long time as it coasts down. This back EMF can fry a VFD's power buss by backfeeding. So it is probably a good idea to have resistor to...
  19. Replies
    14
    Views
    329

    easy to mount casters to that base. Dos the head...

    easy to mount casters to that base. Dos the head have jack screws to adjust the knives?
    Bil lD
  20. Replies
    30
    Views
    1,041

    Yes, On the Huan Yang I am familiar with you...

    Yes, On the Huan Yang I am familiar with you attach a big resistor to the braking terminals only. No other wiring needed. But that wiring has to be safe and not touchable. I would mount it inside...
  21. Replies
    17
    Views
    388

    Old computer running KODI tv for free. hooked to...

    Old computer running KODI tv for free. hooked to a bigger screen. Buy a wireless keyboard and mouse to run it after it is connected and tried out. Or use an old laptop computer
  22. Replies
    30
    Views
    1,041

    Read the rules very carefully... Many machinery...

    Read the rules very carefully... Many machinery auctions do not allow buyers to load out anything. They have to pay a bonded rigger to forklift it to your vehicle. This can be a scam of only one...
  23. Replies
    30
    Views
    1,041

    A disk sander can be used as an extra idler motor...

    A disk sander can be used as an extra idler motor to add more hp to a rpc setup. To brake that sander you will need a vfd that actually has braking terminals. Many smaller China ones do not or...
  24. Only one seller on ebay at $16.91 for 50cm. in...

    Only one seller on ebay at $16.91 for 50cm. in stainless. Tip is to negate 13 and 20 in your search since those are common 1/2 thread counts. Size 1.5" x12tpi is common I see.
    Bil lD.
  25. Replies
    12
    Views
    456

    How is the spindle runout? I bent mine into...

    How is the spindle runout? I bent mine into straight from 0.008. down to 0.002 and said close enough. Simple to do with a pipe clamp just takes several attempts to allow for springback. I could...
Results 1 to 25 of 500
Page 1 of 20 1 2 3 4