This is almost word for word how I did mine, all the way down to using a file (flat on one side, round on the other). I used a thick rubber FERNCO, 6" in diameter that I sliced lengthwise, that it...
Type: Posts; User: Rob Beaupre; Keyword(s):
This is almost word for word how I did mine, all the way down to using a file (flat on one side, round on the other). I used a thick rubber FERNCO, 6" in diameter that I sliced lengthwise, that it...
I had this same issue with the read out for my router. I had to take the sensor (the part that moves up and down on the sensor strip), and turn it end for end. This corrected the problem for the...
Not sure how much you were planning to dismantle it at all for transport but
1.) I would take off the cast iron top - BE SURE to watch for shims at each of the 4 bolts holding the top on, and note...
I'm looking to replace my DP chuck and was wondering if anyone had any opinion on this one from Llambrich.
Or on the quality of Llambrich in general.
Jacobs are more expensive and I'm...
I believe the dial indicator I bought for setting my General 130 planer was a Mitutoyo 1410S. I am no expert in dial indicators but when looking for one I found that AGD Series 1 were the smallest...
I know this was overkill but I made my own pipe hangers. 1/8" x 3/4" flat bar and I made a 6" jig to form the round bottom section, and then used a metal bending jig in a vise to form the top piece....
Thanks Frank and yes, thank you for the correction. I will try to get a recording of the sound and get that here.
I just watched two videos of people replacing the centrifugal switch on VERY...
I have a Craftex CX400 2HP dust collector. The DC is basically brand new, although I bought it 2nd hand from someone so I really just can't return it. It's making a whistling sound just as the...
Thanks to all for the feedback. I'll be looking to install everything with couplings, you're right Andrew if I've already gone this far, why stop short now.
Jim Andrew, thanks for the comment on...
Yes, they did come with the crimping on them. I might ask if they have couplings without crimping, but it'd be quicker for me to just hammer the crimping flat, rather than try to exchange,...
As the title says, I'm starting to install 6" spiral duct (26ga) - (right now its collecting dust on the outside (on the ground) vs installed)
I wanted to know people's experience with installing...