Search:

thanks for all the help. Hope it helps others also.

I am looking for some help finding some 3" disc holders. I bought this setup from WoodturnersCatalog several years ago and finally need some more disc holders. I would like some discs also. These...

Please register me in this drawing. Thanks for all you do.

I would love to be in this drawing.

I just talked to Louis Iturra, and was lucky enough to have his last conversion kit for my saw :)

I know Delta was on the outs, but I think they never went out of business and seem to be going strong. http://www.woodworkersjournal.com/update-delta-power-equipment/

Thanks Matt. I uploaded pictures to the post.

I purchased a used Delta 18" 28-682 bandsaw and now need to purchase some replacement guides. The lower bracket has broke and can no longer hold the thrust bearing piece. The upper guides are not the...

I did have some time last night to try the grinder with no wheels. It did take a couple seconds of churning sounds to actually get the shaft to rotate after flipping the ON switch. Once the shaft...

I am considering just trashing the woodcraft and going with a new jet from CSUSA. The woodcraft is five years old and at the $110 I paid for it is has had a good life.

thanks for all the insight and comments. I am going to work on it this weekend and pull both wheels off and let it run and then add one back at a time. I may also replace the capacitor since it...

The CBN wheels are heavier than the AO wheels that were on it. I also find it strange that the problem didn't come up until after I swapped out to new CBN wheels.

I found several posts on this topic here on SMC. Yesterday after doing a little cleaning and organized after my recent project, I installed two new CBN wheels (80 and 180) on my woodcraft slow...

count me in

Looks great. More pics please.

count me in

count me in

count me in

count me in

count me in

It is a great lathe for the money. Too bad you missed the Woodcraft special in October. I am getting ready to sell mine but I am a little far way from you :) I am upgrading to the mustard beast.

I like the cutter from woodturnerscatalog. It is also a lot cheaper.

I would recommend ReadyNas. I have one and also a Iomega Storcenter and the ReadyNas is a lot better.

the link has been removed. pm me if you want more info and sorry for going against TOS

I am organizing a group buy over on penturners.org if anyone here want to get some stoppers.


Hopefully this post doesnt go against the rules. If so sorry.


edit: the direct link to...